Faber Pro Magnum Installation Instructions Manual

Manual is about: Faber Pro Magnum Wall Mount Canopy Rangehood

Summary of Pro Magnum

  • Page 1

    Version 12/04 - page 1 pro magnum wall mount canopy rangehood • installation instructions • use and care information read and save these instructions the installer must leave these instructions with the homeowner. The homeowner must keep these instructions for future reference and for local electric...

  • Page 2: Warning

    Version 12/04 - page 2 venting requirements determine which venting method is best for your application. Ductwork can extend either through the wall or the roof. The length of the ductwork and the number of elbows should be kept to a minimum to provide efficient performance. The size of the ductwork ...

  • Page 3: Avertissement

    Version 12/04 - page 3 rÈglements d'Évacuation confirmer la sortie d'évacuation - soit par le mur, soit par le toit. Utilisez une longueur de tuyauterie minimale avec les moindres de coudes pour la plus grande efficacité. Le diamètre de tuyauterie doit être uniforme. N'installez jamais 2 coudes ensemb...

  • Page 4: Warning

    Version 12/04 - page 4 tools needed for installation • saber saw or jig saw • drill • 1 1/4" wood drill bit • pliers • phillips screwdriver • flat blade screwdriver • wire stripper or utility knife • metal snips • measuring tape or ruler • level • pencil • caulking gun • duct tape parts supplied for...

  • Page 5

    Version 12/04 - page 5 prepare the wall 1. Disconnect and move freestanding range from cabinet opening to provide easier access for installation. Put a thick, protective covering over cooktop, set-in range or countertop to protect from damage or dirt. 2. Determine and clearly mark with a pencil the ...

  • Page 6

    Version 12/04 - page 6 install the rangehood 1. Remove the unit from the carton and place on a flat surface for assembly. Cover the surface to prevent accidental damage. Remove all parts including the mounting hardware before discarding the carton. 2. Remove the grease filters using two hands (one to ...

  • Page 7

    Version 12/04 - page 7 0 1 0 1 0 1 2 l m v light on/off button ( l ) on/off switch for the halogen lights. Move the switch to "1" to turn the light on and to "0" to turn it off. Blower on/off button ( m ) on/off switch for the blower. Move the switch to "1" to turn the blower on and to "0" to turn i...