Faber Titano Instruction Manual

Manual is about: Extractor hood

Summary of Titano

  • Page 1

    Instructions manual en titano.

  • Page 2

    En 3 3 recommendations and suggestions the instructions for use apply to several versions of this appliance. Accordingly, you may find descriptions of individual features that do not apply to your specific appliance. Installation • the manufacturer will not be held liable for any damages resulting f...

  • Page 3: Characteristics

    En 4 4 characteristics components ref. Q.Ty product components 1 1 hood body complete with: controls, light, suction unit, filters, lower duct 7 1 pvc pipe (fitted) 8 1 inclinable grid (fitted) 9 1 reduction flange ø 150-120 mm 10 1 metal cover ref. Q.Ty assembly components 11 2 wall plugs 11a 2 sb ...

  • Page 4

    En 5 5 dimensions.

  • Page 5: Installation

    En 6 6 installation drilling the wall if the hood is to be connected in the ducting version, with the pipe coming out of the back, re- member that the air venting duct must be created as indicated in the drawing. 0 0 if the hood is fitted in the recirculation version, bear in mind that there must be...

  • Page 6

    En 7 7 mounting the hood body • remove the metal grease filters by turning the handles pro- vided. • adjust the two screws vr, on brackets 11a, to a minimum. • hook the hood canopy onto the two brackets 11a. • from inside the hood canopy, adjust the screws vr to set the hood canopy level. • tighten ...

  • Page 7

    En 8 8 air outlet in a recycling hood version • in case the components requested for the recycling functioning have been removed earlier these have to be positioned again. • put the plastic tube onto the flange 7. • place the air outlet grid 8 on the air outlet. Make sure that the position of the gr...

  • Page 8: Use

    En 9 9 use control panel t1 t2 t3 t4 l button function t1 turns the motor off. - t2 turns the motor on at speed one buttons t1+t2 are on. T3 turns the motor on at speed two buttons t1+t3 are on. Press and hold for 2 seconds to enable shutdown with a 20 minute delay (motor+lights). It is possible to ...

  • Page 9: Maintenance

    En 1 10 maintenance grease filters cleaning metal self- supporting grease filters • the filters must be cleaned every 2 months of operation, or more frequently for particularly heavy usage, and can be washed in a dishwasher. • remove the filters one at a time by pushing them towards the back of the ...