Factor Electronics PA-1000 User And Installation Manual - page 5
www.factorelectronics.com
info@factorelectronics.com
PA-1000/2000 INSTALLATION INSTRUCTIONS
IMPORTANT: The PA-1000/2000 should be situated in a well ventilated location or position. Do not block the vents on the front/back of the
chassis. Proper ventilation is required for normal operation. Do not expose the unit to excessive dust and do not allow dust to build up
on the unit and block the vent holes in the chassis. Do not place the PA-1000/2000 directly above or below heat-generating components
such as another audio amplifier. Be sure to leave at least 2 inches of space to the sides of the chassis with open air flow above and below
the unit.
INSTALLATION:
1. The PA-1000/2000 can be mounted in an equipment rack using the rack kit that is included with the unit.
2. Always disconnect the AC power cord before making any connections.
3. Use good quality 12-14awg 2 conductor stranded copper speaker wire for all speaker connections.
4. Use good quality balanced input cables like the Factor Electronics PRO-XLR cables.
Stereo configuration using four 8ohm speakers. Set the MODE switch to
STE – STEREO. Each channel of the amplifier can broadcast independent
sources from input A or B or be used as a high power stereo amplifier.
Parallel configuration using four 8ohm speakers. Set the MODE switch to
PAR – PARALLEL. Input source A will broadcast to both amplifier outputs.
Use this configuration when all speakers must be driven from the same
source.
5
5