V-rvc-pro owners manual info@factorelectronics.Com www.Factorelectronics.Com premium audio video and power products.
Important note: this owner's manual is provided as an installation and operating aid. Factor electronics does not assume any responsibility as to its accuracy and shall not be liable in tort or contract for any direct, consequential or incidental loss or damage arising from the installation, use or ...
Introduction congratulations and thank you for purchasing a factor electronics product. The factor electronics v-rvc-pro is an in-wall microphone and line level preamplifier with separate volume controls for the inputs and a master volume control. The master volume control provides remote volume con...
8 7 6 5 4 3 2 1 installation and wiring the v-rvc-pro should be wired using good quality cat5e or cat6 cable. It is recommended to use tia/eia 568a cable wiring techniques. It is recommended to use shielded cat5/6 cable with cable runs over 100 feet in length or when connecting multiple v-rvc-pro un...
Installation using the v-rvc-pro and x-music ipod dock the x-music in-wall ipod dock can be used in combination with up to two factor electronics v-rvc-pro in-wall mic/line pre-amplifiers. Connect the rj45 output of the x-music to the rj45 input of the v-rvc-pro. Then connect the rj45 output of the ...
Using the v-rvc-pro with other amplifiers (requires the optional v-rvc-rj45) the v-rvc-pro or multiple v-rvc-pro units can be connected to any amplifier, mixer, pre-amplifier or receiver using the optional v-rvc-rj45 which converts the cat5/6 cable and rj45 jack to individual outputs. The v-rvc-rj45...
Front panel controls and connections diagram f 1. Mic, adjusts the volume of the mic input. 3.Master, adjusts the master volume of the amplifier. 2.Line, adjusts the volume of the line inputs (rca jacks and the 3.5mm stereo jack) 5. Priority, allows the v-rvc-pro to override other sources connected ...
Info@factorelectronics.Com www.Factorelectronics.Com back panel controls and connections ? Mic pht- this applies 24v dc phantom power to pin 2 + and pin 3 – of the xlr microphone input. Phantom power is used to power condenser microphones such as podium microphones, choir microphones and some stage/...
Info@factorelectronics.Com www.Factorelectronics.Com back panel controls /connections & specifications 5. Priority- the v-rvc-pro provides a latching contact switch which can be used to provide constant override of other signals present in the amplifier. Connect the priority contact to the remote mu...
