Fadini Aproli 480 Installation Manual - “B”
RUBBER STOP
RELEASE
LEVER
“B”
25
OPEN
RUBBER STOP
RECOMMENDED STARTING POSITION
BEFORE CLOSE CYCLE
RUBBER STOP ON
THE OUTSIDE OF THE DOOR
The highest power is required to start the close cycle. Therefore it is recommended to fit rubber stops to the door. This will cushion
the door at the end of the up stroke and will keep the door inclined by 5 degrees for a better start. See Pic.12.
CLAMP
RELEASE
LEVER
“B”
LOCKABLE
HATCH DOOR
RELEASE CORD
DOOR SECTION
To release Aproli 480 for hand operations it is available
a device as described above, on request. Turn the key
sharply; this will pull the cord and the lever open. As
an option you can fit the door with a service hatch.
Pic.13
HATCH
RELEASE LEVER
DOOR FROM OUTSIDE
There are two solutions to get access to the operator release lever for hand operations of the door. Either a lock is fitted at a suitable
distance from the release lever, to which it is connected by a steel flexible cord as in Pic.13; or a 12 cm x 12 cm lockable hatch is
provided and fitted to allow a hand to pass from outside to inside and release the lever «B».
POSITION OF THE
EARTH SCREW
CONNECTION
CLOSE
OPEN
ELPRO 6 exp
WITH COVER
APROLI
480
ELECTRIC CABLE TO DANGLE
FREE LENGTH 1.30 METRES
The electric cable which supplies power to the motor/pump is connected by means of terminals, which are located above the oil
container, next to the earth screw connection. The cable must be led along the door to the point where the telescopic arm is welded
to the bar. It is recommended that the cable is allowed to dangle free by 130 cm so that the door can go fully up to the end of the permitted
stroke.
It is essential to make sure that the shaft rotates in the required direction during the first running test. Should it rotate in the opposite
direction, change wire No. 10 with No. 12. Pic. 15
COURTESY
LIGHT
EXTRA CAPACITOR IN CASE OF
POWER SHORTAGE OR TO IMPROVE
THE POWER OF THE OPERATOR
WHEN HEAVY DOORS ARE INVOLVED
TO REVERSE THE DIRECTION OF THE
SHAFT ROTATION SWOP WIRES ROUND
No. 10 AND No. 12 DO NOT CHANGE No.11
10 11 12 13 14
ELPRO 6 exp
9
8
PIC. 14
PIC. 15
PIC. 12
PIC. 13