- DL manuals
- Fagor
- Dishwasher
- LF 073M
- Instructions For Use Manual
Fagor LF 073M Instructions For Use Manual
Summary of LF 073M
Page 1
Manual de instalación y uso del aparato manual de instalação e utilização do aparelho installation manual and instructions for use installations- und bedienungsanleitung.
Page 3: Dishwasher
Dishwasher unpackaging installation and fitting 2 connection to the plumbing the water connection pi- pe is located on the back of the dishwasher: connect the pipe to the water inlet, tighten the connection nut and make sure it is se- curely connected to the appliance. A 1 unpackaging the dishwasher...
Page 4
The hose must run between the wall and the bottom space at the back of the dis- hwasher (b1) so that it is not squashed or overstretched. A fixed drain outlet at a distance of 25 - 100 cm from the floor is recom- mended. Make sure the drain tube is not too tight and that there are no bends or kinks ...
Page 5
4 levelling and positioning legs - levelling worktop i f t h e w o r k t o p i s wooden, fit the plastic protection onto it to prevent the area from being damaged by steam. Fit the front brackets to the dishwasher so that it can be fixed to neighbouring units or the work surface (see point k, page 5...
Page 6
Door an information template is provided with the assembly instructions. Position the template, fix it in place and mark the position of the holes. Drill the holes with a Ø 2.5 mm bit and screw the supports to the panel with the curved part facing downwards. Pick up the door panel and fit the suppor...
Page 7
Integrated beneath a worktop for integrated stainless steel models, the following installation instructions should be taken into account: column-integrated 50 114 mm 600 16 6 min. 25 82 58 9 english 55.
Page 8
B once the dishwasher has been installed correctly, it should be first used on prewash programme: open the dishwasher door. Press the dishwasher on button. Select programme 1 (prewash), with no dishes or detergent. Close the door. The dishwasher will start up automatically. This is to check the i n ...
Page 9: Dishwasher
M a n u a l r e g u l a t i o n 1 if there is a salt regulator like the one shown in the photographs (mod. A-b) inside your dishwasher on the right-hand side, turn it t o t h e n u m b e r t h a t c o r r e s p o n d s t o t h e hardness of the water in your area (see table). To turn it to the corre...
Page 10
Where to put the salt reservoir a sel the dishwasher has a salt container in the bottom of the tub. Important: use dishwasher salt only. On some models, the salt regulator is electric (has no numbers: (see mod. C in the photo) and is regu- lated from the control pa- nel. These models have 5 re- gula...
Page 11
The rinse-aid helps dr ying and prevents drops of water from clin- ging to utensils after was- hing. The rinse-aid contai- ner is located on the inside of the door, next to the detergent container. It has a 4-position dispen- ser for adjusting the amount of rinse-aid to the water quality (the dispen...
Page 12
When do i need to add rinse-aid? The dishwasher itself will inform you of when the rinse aid needs refilling. A pilot light on the design panel will come on when a refill is necessary. Using more detergent and rinse-aid than necessary does not improve the results of your dishwasher and besides leadi...
Page 13
Not all utensils can be washed in a dishwasher. Do not attempt to wash items made of wood or earthenware or plas- tic that is not heat resistant. Stainless steel cut- lery can be washed ea- sily; however, ensure that 2 tableware and utensils. Types and positioning silver cutlery does not come into c...
Page 14
L e s c o u v e r t s , except for knives, cutlery should be placed in the cutlery rack, with the handles at the bottom. P l a c e t h e m o r e delicate items, such as cups, glasses, porcelain or crystal, and standard-size plates in the top rack. Long cutlery has a special place. There are also rac...
Page 15
Adjusting the racks the racks can be adjus- ted in accord with the load. The top rack can be pla- ced at two different heights for washing different-sized plates. In the upper position, the top rack holds standard- size plates of up to 19 cm and the bottom rack holds plates of up to 31 cm. In the lo...
Page 16
3 selecting the wash programme prog on/off button top or bottom load selector top or bottom load pilot lights time delay selector the steps for selecting the wash programme are as follows: o p e n t h e dishwasher door. P r e s s t h e dishwasher on button. Select the wash programme using the prog b...
Page 17
There are various programme types depending on the dishwasher model: it is very important to choose the wash programme in accordance with the type and amount of utensils and level of soiling. 25 g of powder non-concentrated detergent is the equivalent of one and a half flat soup spoons or one tablet...
Page 18
Unless the change affects the duration of the wash programme or involves the time delay option. In this case, press the on/off button ( ) to make any changes. If you press the on/off ( ) button during the wash process, you will have to reprogramme the dishwasher. Button: time delay this makes it pos...
Page 19
When the dishwasher programme ends, a continuous beep will sound for 3 seconds. When you open the dishwasher door you will be able to see that washing has finished as a pilot light will have lit up on the design panel. 6 end of programme after a power cut, the dishwasher continues to work as normal ...
Page 20: Dishwasher
Appliance maintenance and cleaning you should perform the c l e a n i n g o p e r a t i o n s regularly so that your dishwasher will last longer. Yo u s h o u l d d o t h e following every three months: dishwasher • clean the filter. • cleaning the spray arms. • clean the inside. • clean the outside...
Page 21
2 cleaning the sprinklers 4 cleaning the outside of the appliance clean the outside with a cloth and soapy water. Use non-scratch and non- abrasive products. Dry with a cloth. I m p o r t a n t before any cleaning or mainte- nance operations, unplug the dishwasher from the mains. The third spray arm...
Page 22: Troubleshooting
Troubleshooting dishwasher if you find a problem when using your dishwas- her, you will probably be able to solve it by consul- ting the following section. When the dishwasher detects a malfunction, it will give you acoustic or visual warnings, depending on the model. On the top edge of the dishwash...
Page 23
• why won’t the dishwasher start? This may be because: – there is no power. – it isn’t plugged in correctly. – the power fuses have blown. – the dishwasher is not connected to the mains. – you haven’t pressed the on/off button (the pilot light for this button must be on continuously). – the dishwash...
Page 24
2 problems with the quality of the wash • remains of dirt or food on the utensils this may be because: – the wash filter is dirty, blocked or not correctly in place. – the sprinkler holes are dirty, or the sprinklers are being blocked by the dishes. – the detergent is inappropriate or there is an in...
Page 25: Dishwasher
Dishwasher further information 73 when the appliance reaches the end of its service life, you should not dispose of it with the general domestic waste. It can be taken free of charge to the local administrations’ specific selective collection centres, or to distributors who provide this service. Sep...