Summary of LVC–21W
Page 1
Service manual ********* october 200 7 glasswasher models: lvc – 21 w.
Page 2: 0 Table of Contents
I 0 table of contents 0 table of contents ______________________________________________________ i 1 quick start guides______________________________________________________1 2 quick installation _____________________________________________________2 3 specifications ________________________________...
Page 4: First
All plumb ing and electrical connections mu st be made by a qualifie d installer in accord ance with your state and local codes! Run machine to verify that all electrical, water and drain hookups are correct, chemicals am ount are ade quate and the re are no leaks! Quick installation guide l v c-21w...
Page 5: 3 Specifications
3 3 specifications model: lvc-21w performance/capacities capacities heating elements racks per hr.: 22 electric wash tank heater: 2 kw wash tank: 4gal. / 15.4 liters electric booster heater: 2.8 kw water consumption / requirements operating cycles gallons per hr. (max. Use): 20gal. / 75 liters wash ...
Page 6: 4 Installation
4 4 installation 4.1 visual inspection upon receiving your new fagor dishwasher, check the package and the machine for any damages that may have occurred during transportation. Visually inspect the exterior of the package. If damaged, open and inspect the contents with the carrier. Any damage should...
Page 7
5 4.3 data plate the data plate in located on one side of the machine. Under no circumstances should the data plate be removed from the unit. The data plate is essential to identify the particular features of your machine and is of great benefit to installers, operators and maintenance personnel. It...
Page 8
6 the display of the pressure gauge shall be clearly visible of the operator of the machine. The gauge shall have increments of 1 psi (7 kpa) or smaller and shall be accurate to ±2 psi (±14 kpa) in the 15-25 psi (103-172 kpa) range. If the gauge is located upstream of the control valve, it shall be ...
Page 9
7 4.7 electrical connection − to access to the electrical connection block (r) (fig. 1), remove the top cover (t) (fig. 1) and the rear panel (p) (fig. 1). Connect the wires as shown in figure 6. Insert the power cord through the cord holder (e) (fig. 1) and make sure to leave enough cable to remove...
Page 10: 5 Installation Checklist
8 5 installation checklist check off the following items as they are completed before proceeding to operate or service the glasswasher. Has the dishwasher been checked for concealed/hidden damage? Has the dishwasher been properly leveled? Has the service voltage been checked to ensure that it meets ...
Page 11: 6 Operations
9 6 operations 6.1 washing fig.8 control panel • set selector switch (1) to . This will turn your machine on. Indicator light (2) will illuminate. Machine will automatically begin to fill and heat the water in the boiler and tank to the proper temperatures. • wait for the rinse gauge (3) to read ≥ 1...
Page 12
10 6.3 draining and cleaning draining must occur every day and if in a high application; it should be drained after each meal rush! Fig.8 control panel • switch selector switch (1) to the 0 setting. (off) (fig. 8) • remove the overflow tube by inserting a finger into the top of the tube. (fig.10) do...
Page 13
11 6.4 detergent control • use commercial grade, high temperature, low suds liquid detergent. Fagor doesn’t recommend any specific brand name of chemicals. Contact your local chemical distributor for questions concerning your chemical needs. • all machines come equipped with an internal detergent an...
Page 14: 7 Troubleshooting
12 7 troubleshooting first be sure that the “installation checklist” in this manual was completed and check out that all the conditions still remains in effect. For support or further service information contact fagor service department toll free at 1-866-go-fagor (46-32467). The diagnosing, testing...
Page 15
13 symptom possible cause action timer faulty (m) verify the programmer is rotating (m1, m2, m3). If not, check to see that the motor is receiving power. If so, replace the programmer assembly. Ohm out timer motor leads. Faulty rinse valve (v1) verify the wiring and voltage received; if correct, ohm...
Page 16
14 symptom possible cause action overflow tube not removed. Check and remove. Drain pump (bd) clogged. Open drain pump cover and remove debris. (lower front panel; unscrew white removable cover, rotate c/cw) drain hose kinked make sure the drain hose is not kinked drain pump (bd) faulty verify volta...
Page 17
15 8 electrical diagram.
Page 18
16 9 wiring schematic.
Page 19
17 7 n am n 13 22 23 21 11 12 6 na na g am llo ri a m a e d r e v tt 2 r 2 2 2 2 n m a a am/ve t s n r 3 n ~ 380-415 v. Z-433011 vi rs n r g b b m am r r ve a b b rs r n m m n b na ve b na ve ve vi ve b.D. Rs rs rs st / lc ve rs rs g g m a vi tl n ve lm rp prg. P 1 2 am/ve a n tc rc rt mb c lmp ve g...
Page 20: 10 Timer (M)
18 10 timer (m) the cycle timer is comprised of 3 sections (m1 to m3). Each one has a 3 position micro switch (line /normally closed /normally open) and 1 drive motor. M1: this is the (on) cycle micro, and stays activated throughout the completion of the cycle. The m1 line in ( violet ) wire comes f...
Page 21
19 12 detergent pump new location lvc-21w procedure: 1- open front bottom panel 2- be sure that the bracket on the pump is the one shown above (part #: z208909) 3- if not, attach pump to the bracket (side b – fig. 1) with (2) bolts, (2) washers and (2) nuts supplied 4- use screw and nut supplied to ...
Page 22: 13 Deliming
20 13 deliming in order to maintain dishwasher at optimum conditions, it is requested to remove lime and corrosion deposits on a frequent basis. A deliming solution should be available from your chemical supplier. Read and follow all instructions on the label of the deliming solution. Operations: • ...
Page 23: 15 Warranty Guidelines
21 15 warranty guidelines 1. Service issues when a service issue occurs, the end user must call fagor to report the problem. Our toll free number: 1-866-go-fagor is located in the front of the machine. If the issue can not be resolved by phone, fagor will contact the closest authorized service agenc...
Page 24
Fagor commercial, inc. 12800 nw 38 th ave. Miami, fl. 33054 tel: (305) 779 0170 fax: (305) 779 0173 1-866-go-fagor www.Fagorcommercial.Com.