Fahrenheit Technologies Endurance 50F Installation & Operation Manual - Igniter Replacement
27
IGNITER REPLACEMENT
EndURancE 50F IGNITER REPLACEMENT
Igniter Removal
1. Remove igniter access Panel, shown in Figure 2 on page 5.
2. Remove wire connectors and rubber tubing from the ignitor.
3. Pull the ignitor out (breaking the silicone that is holding the
ignitor in place).
Igniter Installation
1. Slide igniter into the ignite tube (seal with high temperature
silicone sealant).
2. Install wire connectors and rubber tubing to the igniter.
3. Install igniter access Panel, shown in Figure 2 on page 5.
Safe Operation
1. Disposal of Ashes – ashes should be placed in a metal
container with a tight fitting lid. The closed container of ash-
es should be placed on a non-combustible floor or on the
ground, well away from all combustible materials, pending
final disposal. If the ashes are to be disposed by burial in
soil or otherwise locally dispersed, they should be retained
in the container until all cinders have thoroughly cooled.
2. Never use gasoline or gasoline types such as lantern fluid,
kerosene, charcoal lighter fluid or similar liquids to start
or improve a fire in this furnace. Keep all such liquids well
away from the furnace while it is in use.
3. Creosote, Soot and Fly Ash – The formation and the
need for removal. The products of combustion will contain
small particles of fly ash. The fly ash will collect in the vent-
ing system and restrict the flow of flue gases. Incomplete
combustion, such as occurs during start-up and shut-down,
or incorrect operation of the furnace will lead to some
soot or creosote formation which will collect in the venting
system. The exhaust system should be inspected regularly
during the heating season to determine if creosote buildup
has occurred. check more frequently at first to determine
a schedule for cleaning the venting system based on in-
dividual use of this bio-burning furnace. If creosote has
accumulated, it should be removed to reduce the risk of a
chimney fire.
4. Do Not Over-Fire This Unit – Follow all instructions re-
garding the proper use of this furnace.
Figure 25