M-bfs35-45ow.Doc issue 3225-aug 01 issue 3549-feb 06 blagden street sheffield s2 5qs england tel: +44 (0) 114 276 7921 fax: +44 (0) 114 272 0965 email: sales@fairport.Uk.Com website: www.Fairport.Uk.Com operator's manual unit 32 the bell centre newton road manor royal crawley west sussex rh10 9fz te...
M-bfs35-45ow.Doc issue 3225-aug 01 1 contents page 1. Description ................................................................................................ 1 2. Technical specification ........................................................................ 1 3. Safety precautions and informa...
M-bfs35-45ow.Doc issue 3225-aug 01 2 performance blade speed 2750rpm 2750rpm at engine speed of 3600rpm 3600rpm max depth of cut 100mm 150mm blade data maximum diameter: 350mm for the bfs35 450mm for the bfs45 bore diameter 25.4mm guaranteed sound power, 108 lwa db(a) 3. Safety precautions and infor...
M-bfs35-45ow.Doc issue 3225-aug 01 3 the machine spindle as indicated by the arrow on the blade guard. 12. Ensure that the speed marked on the blade is not less than the no-load blade speed of the machine. 13. Ensure that the blade is of the correct type for the material to be cut. 14. To prevent ac...
M-bfs35-45ow.Doc issue 3225-aug 01 4 safety pictograms used on this equipment wear ear protectors wear safety boots wear eye protection read manual before using this equipment 4. Removal and fitting of blades remove spark plug lead from petrol engine. Raise the front of the saw to its maximum height...
M-bfs35-45ow.Doc issue 3225-aug 01 5 remove spanner holding the drive shaft. Refit the blade guard and make secure. Replace spark plug lead (petrol engines). Check that the sawing guide is in alignment with the blade. Adjust guide if necessary. 5. Operating instructions draw a chalk line along the l...
M-bfs35-45ow.Doc issue 3225-aug 01 6 push saw forwards, gently but firmly following the chalk line. At the end of the cut loosen lock knob and wind the blade out of the cut by turning handle clockwise. Slow engine and reposition for subsequent pass. Stop the engine by slowing to tick-over and pressi...
M-bfs35-45ow.Doc issue 3225-aug 01 7 a more comprehensive manual suitable for workshop use is available from fairport construction equipment ltd. 8. Warranty conditions and claims procedure all products supplied by fairport construction equipment ltd (hereafter referred to as fce) are warranted to b...
M-bfs35-45ow.Doc issue 3225-aug 01 8 products are only covered by this warranty in the country to where they were supplied by fce. Warranty on products applies only to the original user of the equipment. This warranty shall not apply if the serial number or other identifying numbers or marks applied...
M-bfs35-45ow.Doc issue 3225-aug 01 9 ec declaration of conformity we fairport construction equipment limited blagden street sheffield s2 5qs declare that the product bfs 35/45 manufactured from 1 sept 2004 conforms to the following directives: 89/336/eec, 89/392/eec, 91/368/eec, 2000/14/ec uses the ...
