Faithfull FAIAUTYINFLO User Manual - page 2
2
3
GENERAL SAFETY RULES
● Before using this product, please
check the lighter socket (12V DC
output) to make sure there is no
rust or any other residue in order
to prevent any damage or danger
caused by poor conductivity and
power supply overheating.
● Please check the recommended
air pressure of the vehicle tyres
and carefully watch the pressure
gauge while inflating to avoid over-
inflation.
● You should start the engine when
using the air compressor to ensure
the battery capacity is maintained
and pump work normally.
● Do not touch the air hose while in
use or just after use.
● After 10 minutes of continuous use,
switch off the inflator for 20 minutes
to allow the unit to cool down.
● After use, please tuck the power
cord and air hose into their locking
slots to prevent any damage to the
power cord and hose.
● Use only 12V direct current power
sockets. Do not use this product
with any other type of power
source.
● Do not tangle the power cord
together to avoid potential electrical
danger.
● If the unit emits an abnormal noise
please stop and immediately check
for the cause of the problem.
● Keep children away from this
compressor while in use.
● Avoid dropping the product and/
or causing severe impacts to the
compressor.
● Do not over expose the unit to
direct sunlight.
● Do not use in damp areas or
around flammable materials.
● Do not attempt to make any
modifications, disassemble or
repair this product either by
yourself or by any non-technicians.
USING THE AIR COMPRESSOR
1. Attach the air nozzle to the tyre
valve and tighten it clockwise.
2. Start the vehicle’s engine.
3. Plug the 12V DC adapter into the
cigarette lighter socket.
4. Press the Power Switch to ON to
start the air compressor. Carefully
observe the air pressure using
the Pressure Gauge and press
the Power Switch to OFF once
the desired PSI/BAR pressure is
reached.
5. Lift the thumb lock up and pull off
the air hose from the tyre valve.
Remove the 12V adapter from the
cigarette lighter socket.
6. Turn off the car engine.
7. Wrap the wire and air hose and
tuck them into their locking slots.
CAUTION
Always check and inflate tyres when cold, never just after driving your vehicle
as the heat in the tyres will give a false higher reading.
The gauge is for indication purposes only. It is recommended you check your
tyre pressures with a calibrated gauge.