Faithfull FPP CHAINSS Operator's Manual
5. After you have fi nished sharpening all of the
teeth on the chain, turn off the machine by
pushing the red button on the Switch Plate (5)
and unplug the unit.
NO VOLT RELEASE SWITCH For your safety
this machine is fi tted with a no volt release
switch and will not restart automatically if the
power supply is interrupted. After a power
failure the green button must be pressed to
resume operation of the motor.
6. Loosen the Lock Wheel (18) and reset the
angle so that the fi rst tooth that hasn’t been sharpened is positioned against the
Chain Stop (23) and locked in as explained on page 6. See FIGURE 11.
7. As you did with the fi rst half of the chain, be sure to lower the Top Housing (4) so that
the Grinding Wheel (8) skims the chain tooth, and lock it in place. See page 5. Follow
all of the steps on page 5 double checking everything before you plug in the machine
and turn it on again.
Remember to turn the machine off and unplug it if you need to make any adjustments.
8. After you repeat all of the steps under sharpening on page 6, your chain is ready to be
mounted on your saw.
Maintenance
1. Keep the Sharpener clean and free of dust, metal debris and dirt.
2. Check the grinding wheel before each use to make sure it isn’t damaged. Do not use a
grinding wheel if it is chipped, cracked, or worn. You can check if the wheel has cracks
not visible to the human eye by hanging it up by the central hole and tapping it with a
non-metal object (ie: screwdriver handle). If it is in good condition it will produce a
metallic ringing sound. A dull sound indicates a crack or break.
3. Replace the grinding wheel when it grinds down to a diameter of 75mm (3 inches).
FIGURE 11
Lock Wheel (18)
Chain Stop (23)
FAITHFULL TOOLS
Long Reach, Galleon Boulevard,
Crossways Business Park, Dartford,
Kent, DA2 6QE, United Kingdom
E-mail: enquiries@faithfulltools.com
www.faithfulltools.com
Guarantee
The Faithfull electric chainsaw sharpener carries a full one year
warranty. If this product becomes defective due to faulty materials
or workmanship within 12 months from the date of purchase, we
shall at our discretion replace all defective parts without charge,
or replace the product free of charge provided that:
The product has not been used in a trade application or for hire purposes.
The product has not been subjected to misuse, neglect or used
for a purpose that it is not intended for.
The product has not sustained damage to any part, caused by
other objects, substances or by accident.
Repairs have not been carried out by unauthorised Faithfull repair
agents.
This guarantee is offered as an extra benefi t and is additional to
consumers statutory rights.
In all instances proof of purchase will be required before any repair
or replacement of this product can be provided.
EC Declaration of Conformity
This product is inconformity with the following
standards or standardised documents.
EN 55014-1: 2006
EN 55014-2: 1997/+A1: 2001
EN 61000-3-2: 2006
EN 61000-3-3: 1995/+A1: 2001/+A2: 2005
EMC directive (2004/108/EC)
Replacement Grinding Wheel: Product Code FPP CHAINSSW
ELECTRIC CHAINSAW
SHARPENER
Assembly and Operating Instructions
FPP CHAINSS