Fakir E-240 Instruction Manual - page 9
9
• lf required, the connecting lead has to be
replaced together with the cable rewind by
an autorized Fakir After-Sales-Service only.
• Before any maintenance operation or
replacing a filter, and after use, switch off
the appliance and pull out the mains plug.
• Keep the nozzles and ends of tubes well
away from the eyes and ears.
• The appliance must only be used for dry
vacuum cleaning. lt is not a dual-purpose
(wet/dry) vacuum cleaner.
• Do not use the appliance to pick up hot or
glowing substances.
• Do not use the appliance to pick up any
solvents, explosive liquids or gases.
• Do not store the appliance in the open air.
• Do not exposure the machine to weather,
humidity nor excessive heat.
• Clean the appliance only with a dry or
slightly moist cloth. Do not allow any of the
electrical components (switches, plug,
socket, electronics etc.) to come into contact
with water.
• Your vacuum cleaner is equipped with
HEPA (High Efficiency Particulate Air) H11.
HEPA filter is a high filtration capability filter,
made of special fibre, which is able to keep
almost all particles bigger than 0, 3 micron.
H11 number refers to filter penetrability.
HEPA H11 filter keeps 95, 5% of particles
bigger than 0, 3 micron.
Keep this manual for future use.
Technical Data
Model: E 240 Dry Type Vacuum Cleaner
Colours: Silver
Power: Max. 2400 W
Mains Voltage: 230 V
Nominal Frequency: 50 Hz
Operation
Unpack the appliance and all its
accessoires. Check the contents of all
accessoires.
Attention:
Always transport or ship the appliance in
its Original packaging to avoid damages.
Before you start up your vacuum cleaner:
• ‹nsert the end of the suction hose (1) into
the intake opening (2) of the vacuum
cleaner, until it locks with an audible click.
• Insert the other end of the suction hose (1)
into telescopic tube (2).
• Insert the floor brush (1) into the end of
telescopic tube (4).
• Adjust the desired length of the suction
tube (depending on the height of the person
operating the appliance) by pressing the
"1" button and slide the tubes in the direction
indicated by the arrows.
ATTENTION:
Be careful during pulling the
cord out, the yellow mark on the cord show
the end of the cord.