Fakir MRC 36 Instruction Manual - page 12
INSTALLING THE WALL
MOUNTED CHARGING BASE
It is recommended that the charging
base should be mounted on a wall to
provide a convenient storage and
charging point for the cleaner.
1. Find a suitable indoor wall location near
a mains power socket but out of the reach
of children.
2. Do not mount the charging base in direct
sunlight or close to a heating source.
3. Make sure that there are no hidden
electrical wires or pipes in the chosen
location.
4. Insert the adaptor plug through the rear
of the charging base and twist to lock
into position.
5. Mark the location of the mounting holes
and drill two suitable holes, insert the
rawl plugs supplied into the holes.
6. Make sure that the charging plug is
correctly located and that the adaptor
lead is threaded through the slot in the
charging base. Excess lead can be
stored at the rear of the charging base.
7. Screw the charging base to the wall,
using the screws provided.
8. The cleaner should be stored in the
charging base. This will ensure that the
battery remains fully charged and the
cleaner always ready for use.
STORAGE
We recommend that the accessories are
stored as shown to prevent them getting
lost or damaged. The turbo brush
attached to the vacuum cleaner and the
accessories place onto the charger as
shown.
USING RECHARGEABLE VACUUM
CLEANER
NOTE:
Before using the vacuum cleaner it is
recommended that you charge for a
full 16 hours to ensure maximum
performance.
• Plug the charging stand into a mains
outlet socket (220-230V ~50HZ).
• To charge the unit, slide the vacuum
cleaner into the charging stand. The
charging LED indicator will light up to
indicate charging is in progress.
NOTE:
The On/Off switch must be in the off
position for charging.
12