Fakir VIGOR PLUS Instruction Manual - page 19
4. Clean and dry
• After cleaning, please completely dry
the unit before use. Otherwise, it could
cause electrical shock or malfunction.
• If the front cover of the plasma dust
collector is not properly installed, no
electricity will be connected.
• Please make sure the plastic wrap fort
he electrical discharge wire is located
at its proper position.
Replacing filters
• Please change filter when the FILTER
REPLACE indicator is glowing.
• Please refer to page 7 on how to
replace filters.
Replacing UV Lamp
• The life span of UV lamp is about
5.000 hours. Replace UV lamp when it
is damaged or when no blue light is
observed.
• Take down the front cover, plasma
dust collector and filters befoe
replacing the UV lamp. (refer to page
7 on how to disasemble)
• Softly twist the UV lamp, remove the
lamp tube from its position, and insert
a lamp tube of the same model.
Reinstalling
• After cleaning and replacing filters,
reinstate the PIN CLEAN and FILTER
REPLACE indicators. Otherwise the
two indicators would remaining
glowing after turning on the unit.
• While reinstalling, the unit should
remain plugged in with the socket but
being turned off.
• The FILTER READY button is inside
the unit (cannot be reached with
finger). Please use a toothpick or other
sharp object to push the FILTER
READY button.
How to reinstate
1. PIN CLEAN Indicator
• When the unit is turned off, the
reinstating process for PIN CLEAN
indicator is done by pushing both the
FILTER READY and the TIME buttons
at the same time.
2. FILTER REPLACE Indicator
• When the unit is turned off, the
reinstating process for FILTER
REPLACE indicator is done by
pushing both the FILTER READY and
the FLOW buttons at the same time.
Cleaning Steps
1. Take down the front cover of the unit
and the dust sensor cover.
2. Take out the Dust and Irritant Sensor,
carefully unplug the connecting cord
and make notes of the plugging
direction at the same time.
19