Fakro ZWG1 User Manual - page 8
3.4. Deleting device from a pair of controller buttons (DELETE function)
This function deletes from controller's memory the device associated with a pair of buttons on a
selected channel. However, it does not remove the device form the “Z-Wave” network. This function is
accessible from PRIMARY and SECONDARY controllers. The procedure of device deleting from a pair of
controller buttons is presented in Figure 5.
*) Programming error can be caused by:
•
failure to press the programming button within 10 seconds from the controller signaling its readiness for
deleting the device from selected pair of buttons;
•
long distance between the controller and device.
11.11.15 NC818
8/16
©2012, FAKRO
Figure 5: Deleting device from a pair of buttons on the controllers
4. The controller is signalizing
successful device deleting (buttons
light up for 2-3 sec. as presented
in the drawing).
5*. Programming error – button
flashing for 2-3 sec. as presented in
the drawing.
1. Within 1.5 sec., press:
- “In/Ex”(1) button twice and then
- the button from this pair of buttons
which operates the device to be
removed (e.g. 2).
2. The controller is signalising
readiness for device deleting (button
lights up for 10 sec. as presented in
the drawing).
3. Press “P” button on the device
and hold it for 0.5 sec. (see Device
Programming Manual).
x1
x1
1
2
x1
x2
Note!!!
In the newer controller version, interrupting any procedure is possible by pressing the “IN/EX” button. In the
older version, it is necessary to wait 10 seconds until the error is signalled by the controller or reset it by removing the
batteries.