Falco HEE82-900MM Use And Care Manual - page 16
The “automatic stop timer” delays stopping of the hood, which will
continue functioning for 15 minutes at the operating speed set at the
time this function is activated.
•COMANDS PATTERN :( Fig.18)
A= Filtering system / Set clock
B= Delay Timer
C= Speed S1/ “-” adjust / off
D= Digital display
E= Speed S1/ “+” adjust / off
F= Alarm
G= Light
When the Key A is flashing, at the same time “
”is flashing on the
digital display, it reminds the user to clean the filters. After it’s cleaned and
then assemble back, push the key A till the light is off to set the function
again.
When pushing key A for 3 seconds, the clock “
”on the digital
display flashing, push key A to switch to set hours and minutes, and then
push C or E to set the correct time. The Clock’s system is 24 hours.
When the motor is on, push the key B, the light is on, at the same time it
shows “
” is flashing as well on the digital display,and to
push key B to switch hours and minutes, and it’s to set the time to
automatically shut off the motor by pushing key C or E. Push key B for 3
seconds to stop the delay timer.
Push key C or E, the first speed is on, and it shows “
” on the digital
display,and push key C once again to turn off;To run the 2
nd
, 3
rd
and
“Turbo” speed, then push Key E. If it’s “Turbo”speed on, then push
E once again to turn off; and to push key C down to 3
rd
, 2
nd
and 1
st
speed. On the special function set, after the speed “TURBO” runs for
2 minutes, it automatically switches to 3
rd
speed.
Push the key F, the light is flashing, and it shows“
” flashing on
the digital display,to push key F to switch hours and minutes,and to set
the alarm time by pushing the key C or E. To stop the alarm, push the
key F. And to cancel the alarm set, then push the key F for 3 seconds.
Push the key G, the light is on, and it shows“
” on the digital display,
and push the G again to turn off the light.
16