1. DL manuals
  2. Falco Systems
  3. Amplifier
  4. WMA-005
  5. User Manual

Falco Systems WMA-005 User Manual

Summary of WMA-005

  • Page 1

    User manual -75v to +75v output dc to 20khz at -3db full power bandwidth single power supply 18v – 30v dc, battery power possible 50k Ω output impedance stable with all capacitive loads, generates no overshoot short-circuit protected output for mems devices, eo- modulators, pzt (piezo) positioning, ...

  • Page 2

    About this manual this user manual is an integral part of the falco systems wma-005 amplifier product. Please read it carefully and pay attention to the recommendations and the instructions for safe use. General description the falco systems wma-005 is a high voltage amplifier that runs from an 18 –...

  • Page 3

    Ii environment (domestic, light industrial). - the power supply connected to the wma-005 should be double insulated (class ii) or a selv type (selv = safety extra low voltage, typically a battery). - the wma-005 is a class iii product. Do not connect the amplifier to the mains safety earth. If this ...

  • Page 4

    100pf/m. The cables that are connected may well limit the maximum usable frequency. If output monitoring is required, it is recommended to connect a 10x oscilloscope probe to the output. A special bnc to probe tip connector is usually supplied with the probe (fig. 1). However, the user can choose a ...

  • Page 5

    200 150 100 50 0 10 0 10 1 10 2 10 3 10 4 10 5 wma -005 wma -005lf amplitude (mv pp ) frequency (hz) figure 3. Frequency response at 200mv pp output voltage figure 4. 150v pp 1khz square wave figure 5. Full scale 10khz square wave figure 6. 30mv pp 1khz small square wave output signal.

  • Page 6

    0pf 100pf 470pf 1nf 2.2nf 10nf figure 7. Full-power 1khz square wave response with different capacitive loading conditions. The 50k Ω output resistor limits the speed at which the capacitor can be charged. Figure 8. Triangle wave 150v pp 1khz figure 9. Sine wave 150v pp 1khz figure 10. Noise (less t...

  • Page 7

    Figure 11. Noise (about 0.2mv peak-peak or, equivalently, less than 0.1mv rms) and typical offset - 1.3mv) for the wma-005lf. The offset may change (becomes less) with the impedance of the driving voltage source at the input of the wma-005. Technical specifications amplification: amplification: ampl...

  • Page 8

    Without charge. The product will be returned to the customer prepaid. The warranty does not apply to: - exterior finish or appearance - malfunction resulting from use or operation of the product other than as specified in the user manual - malfunctioning due to misuse or abuse of the product - malfu...