Summary of Daymak
Page 1
Falcon user manual.
Page 2: About Daymak
About daymak daymak is one of canada’s largest alternative vehicle providers. We design, engineer, man- ufacture, import and repair everything from recreational dirt bikes, go-karts and electric golf cars to alternative transportation solutions such as e-bikes and gas scooters. Our electric bicycles...
Page 3: Table of Contents
Table of contents introduction......................................................................................................................................................4 part diagrams ...........................................................................................................
Page 4: Introduction
4 introduction e-bikes riding an electric bicycle is a great way to hop around town conveniently and cheaply. E- bikes represent a natural progression in the development of urban transportation. Using only small amounts of electricity, e-bikes have the potential to radically reduce the amount of pol...
Page 5: Part Diagrams
5 part diagrams diagram 1: the falcon this diagram illustrates the various parts of your falcon. Please note that many of these parts are not us- er-serviceable and should be repaired only by trained professionals. This is especially true of the electrical systems and the mechanical components. 1 2 ...
Page 6: Product Specifi Cations
6 product specifi cations max speed 20 km/h battery lithium battery range (from full charge) 55 km minimum turning radius zero (turns on the spot) optimum tire pressure 1.0bar/100kpa/15psi vehicle weight 55 kg vehicle footprint 65 x 49 cm chassis height 10.0 cm handlebar height 90 ~120 cm (adjustable...
Page 7: Components
7 components handlebar the handlebar maintains balance and controls the direction of the vehicle. The front and rear of the handlebar is shown below. The height of the handlebar can be adjusted to suit the rider: warning the handlebars cannot tilt in excess of 450 left or right around the axis point...
Page 8
8 warning to avoid injury, always hold the handlebar fi rmly during power-up, while riding or when shutting the power off . Display panel the display panel shows information about the falcon’s operations. Make sure to install both batteries - the battery indicator(s) should both turn on when install...
Page 9
9 wheels the wheels bear the weight of the vehicle and the rider. The tire pressure is 15psi/100kpa. Please ensure that both tires are equally pressurized before riding the falcon. Foot pads the foot pads support the rider’s feet. While riding, both feet should always be positioned in the middle of ...
Page 10: Operating Instructions
10 warning in the event that the vehicle is not used for an extended period, it is advised to charge the batteries once every 30 days, otherwise irreversible damage to the battery can occur. At the bare minimum the battery must be charged once every three months. If the vehicle is to be stored, disc...
Page 11
11 to mount the vehicle, wait for the 4 red indicator lights in the middle to stop fl ashing. Step onto the unit with one foot to feel the balance. If the unit feels balanced, step on the vehi- cle with your other foot. Keep your body upright to control the unit and achieve stability. While holding ...
Page 12: Parts Replacement Schedule
12 parts replacement schedule directional potentiometer replace annually or for every 1,000 km traveled handlebar suspension gas springs replace annually or for every 1,000 km traveled tires replace both tires if tread depth is less than 0.5mm gearbox oil change oil for every 2,000 km traveled.
Page 13: Annex 1
13 annex 1 using the remote control locking and unlocking the falcon in standby mode, press the lock key until you hear a “beep” sound. The status lights should fl ash on the display panel, and the lights will eventually turn off . It is now in the lock state - an alarm will trigger and the handleba...
Page 14
14 calibrating the balance point when riding for the fi rst time or after an extended period, it is a good idea to calibrate the system to fi nd a balance point. While in the off state, press the power button and the mode button together for two seconds. After a few “beeps,” the vehicle will calibra...