Falcon Digital Power Supply Unit Operator's Manual - page 4
Operating Modes
Note: The turntable belt MUST be on the SMALL pulley for proper operation.
Standby Mode: The PSU will power up in Standby Mode as indicated by 3 dashes:
Sleep Mode: While in Standby Mode, if no activity is detected for 5 min., the PSU will revert to
Sleep Mode and blank the display.
Normal Mode: To Exit Sleep or Standby Mode, press and release the Stby button. The PSU will
revert to the last used speed and output the appropriate AC signal to the motor. The display will
show the currently selected speed or offset:
Soft Start: Whenever the Falcon PSU exits Standby Mode, it starts the platter at ~20RPM and
evenly ramps up the speed to prevent “burn out” on the belt. This greatly extends the belt life and
improves long term speed stability.
To change between 33.3 and 45.0 RPM, press and release the Stby button.
To adjust the turntable speed in 0.1 RPM increments, press and release the Plus or Minus buttons.
To stop the turntable platter and return to Standby Mode, press and hold the Stby button until the
3 dashes are displayed.