1. DL manuals
  2. Falcon
  3. Fryer
  4. E401
  5. Installation, Servicing And User Instructions Manual

Falcon E401 Installation, Servicing And User Instructions Manual

Summary of E401

  • Page 1

    E401/e402 e401f/e402f fryers installation, servicing and user instructions important the installer must ensure that the installation of the appliance is in conformity with these instructions and national regulations in force at the time of installation. Particular attention must be paid to - bs7671 ...

  • Page 2: Important Information

    Important information warranty policy shortlist warranty does not cover :- • correcting faults caused by incorrect installation of a product. • where an engineer cannot gain access to a site or a product. • repeat commission visits. • replacement of any parts where damage has been caused by misuse. ...

  • Page 3: Section 1 - Installation

    Section 1 - installation unless otherwise stated, parts been protected by the manufacturer not to be adjusted by the installer. Please ensure that any plastic coatings are to use. Before operation, the pan thoroughly cleaned and dried. Discolouration of heated parts is caused testing to ensure a sat...

  • Page 4: Section 2 - Assembly And

    Section 2 - assembly and commissioning the electrical cable must be connected in accordance with the various regulations listed on the cover of this manual. 2.1 assembly a) unpack appliance b) unpack fryer baskets and accessories. C) place element guard and baskets in pan. D) level appliance and fit...

  • Page 5

    2.3.3 all models - additional controls (see figure 4) figure 4 – all models - additional controls the following additional controls are located behind cabinet door. 1. Fryer on/off switch cuts power to appliance. 2. Filtration pump switch – e401f & e402f only energises filtration pump. 3. Temperatur...

  • Page 6: Section 3 -

    Section 3 - servicing and conversion before attempting any servicing, turn off the electrical supply. Take steps to ensure that these cannot be inadvertently turned on. After any maintenance task, check the appliance to ensure that it performs safely and correctly as described in section 2.5. 3.1 in...

  • Page 7: Section 4 - Spares

    Section 4 - spares when ordering spare parts, always quote the appliance type and serial number. This information will be found on the data plate. Section 5 - critical dimensions 7.

  • Page 8: Section 6 -

    Section 6 - operating instructions the fryers are of single pan type and the following units are covered by this manual. E401 - manual control model. E402 - four product key electronic control model. E401f - manual control model with built-in filtration. E402f - four product key electronic control m...

  • Page 9

    6.2.2 fryer maximum basket loading (all models) pre-blanched chilled fries– 2 x 1.5kg baskets. Frozen fries – 2 x 1.2kg baskets. 6.2.3 using the controller e401/401f models only - manually operated when unit has been switched on as detailed in section 6.2.1 above, fryer may be operated as follows. O...

  • Page 10: Section 7 -

    6.3 programming the e402/402f display descriptions louu controller is in operating mode. Actual vat temperature is more than 10° below programmed vat temperature. Redy controller is in operating mode. Actual vat temperature is within proper cooking temperature range. The vat is ready to start a cook...

  • Page 11: Section 8 -

    7.1 starting the filtration process (all models). 1. Turn unit off at on/off switch and allow oil to cool below 170°c (or if cold, heat to minimum temperature of 60°c). Open cabinet door and pull filter bucket forward. 2. Ensure bucket is clean and emptied of all oil and debris. Refer to section 8 f...

  • Page 12

    4. Raise elements using tool provided (located behind unit door). Rest elements on rear support bar. 5. With drain valve open, remove any traces of debris from fry pot using a clean, damp cloth. Note: care should be taken not to damage sensors that are secured to elements. 6. Remove strainer and mic...

  • Page 13

    E401f wiring diagram.

  • Page 14

    E401 wiring diagram.

  • Page 15

    E402f wiring diagram.

  • Page 16

    E402 wiring diagram.

  • Page 17

    E401f circuit diagram.

  • Page 18

    E401 circuit diagram.

  • Page 19

    E402f circuit diagram.

  • Page 20

    E402 circuit diagram.