Falcon Elan 110 Dual Fuel User's Manual & Installation Instructions - 9. Servicing
WARNING – SERVICING TO BE CARRIED OUT ONLY BY AN AUTHORISED PERSON
Disconnect from electricity before servicing. Check appliance is safe when you have finished.
32
Art No 215-0028 - Handrail fascia fixings
A
B
9. Servicing
n
n
BEFORE SERVICING ANY GAS CARRYING
COMPONENTS TURN OFF THE GAS SUPPLY
n
n
Check the appliance is gas sound after completion
of service. When checking for gas leaks DO NOT use
washing up liquid – this can corrode. Use a product
specifically manufactured for leak detection.
n
n
DO NOT use reconditioned or unauthorised gas
controls.
n
n
Disconnect from the electricity supply before
servicing, particularly before removing any of the
following: control panel, side panels, hotplate tray
or any electrical components or covers.
n
n
Before electrical reconnection, check that the
appliance is electrically safe.
1 Panels & Handrails
1.1 To Remove the Handrail
Remove the plastic blanking plugs (Fig.9-1) and remove
the 2 end bracket fixing screws.
1.2 To Remove the Control Panel
DISCONNECT FROM THE ELECTRICITY SUPPLY.
Pull off all the control knobs. Remove the handrail
(see 1.1). Remove the 2 cross-headed screws that were
hidden by the handrail end brackets.
Open the grill door and right-hand oven door and
remove the 2 screws underneath the control panel
(Fig.9-2).
Pull the control panel forward and support it so that the
wires are not strained.
Reassemble in reverse order. When replacing leads, refer
to the wiring diagram.
Check the operation of the timer, ignition, and oven
light switches.
1.3 To Remove a Side Panel
DISCONNECT FROM THE ELECTRICITY SUPPLY.
Remove the control panel (see 1.2). Pull the cooker
forward. Remove the 4 retaining screws from each
panel (2 at the front and 2 at the rear). The lower front
retaining screws (1 each side) are situated beneath the
lower edge at the front corners of the side panels
Reassemble in reverse order.
2 Hotplate
2.1 To Remove the Hotplate Top
DISCONNECT FROM THE ELECTRICITY SUPPLY.
Remove the pan supports, hotplate burner caps and
tops. Remove the screws holding the hotplate burners
to the hotplate (but not the spark electrode fixing
screws).
ArtNo.210-0009 - Classic
removing the handles
Fig.9-1
Fig.9-3
Fig.9-2
A
B
C
ArtNo.311-0010 Injectors
Fig.9-4
A – Jet, B – Internal injector, C – External injector
Wok burner (some
models only)
Standard burner
A
Fig.9-5