Falcon g3478 Installation & Service Manual

Summary of g3478

  • Page 1

    G3478 steaming oven installation and servicing instructions this appliance must be installed and serviced by a competent person as stipulated by the gas safety (installation & use) regulations. Important the installer must ensure that the installation of the appliance is in conformity with these ins...

  • Page 2: Important Information

    Important information warranty policy shortlist warranty does not cover :- • correcting faults caused by incorrect installation of a product. • where an engineer cannot gain access to a site or a product. • repeat commission visits. • replacement of any parts where damage has been caused by misuse. ...

  • Page 3

    1.4 gas supply the incoming service must be of sufficient size to supply full rate without excessive pressure drop. A meter is connected to the service pipe by gas supplier. Any existing meter should be checked by supplier to ensure it is of adequate capacity to pass the required rate of gas for the...

  • Page 4

    2.4 connection to electricity supply not applicable to this appliance. 2.5 pre-commissioning check after installation and assembly, the following checks must be carried out to ensure satisfactory operation of the unit. Failure to do this may result in damage to appliance or necessitate a service cal...

  • Page 5

    Section 3 - servicing and conversion important before attempting any service operation, turn off isolating cock and take steps to ensure it is not inadvertently turned on during task. Ensure unit has cooled sufficiently to allow safe maintenance to be carried out. After any such maintenance task, ch...

  • Page 6

    3.10 to clean ball valve turn off mains water supply and drain steamer tank at draw off tap. Remove cistern lid. Remove split pin from valve body. Raise ball valve arm slightly and withdraw from valve socket. Unscrew cap at valve end and extract valve plug. Clean all components with a soft rag. Do n...

  • Page 7

    3.12 ignition system faults a) if spark igniter does not light pilot, check for a spark and gas. If no spark is evident inspect electrode to ensure ceramic is not cracked and that igniter lead is correctly located. Check insulation on lead for damage also. Use an insulated screwdriver to form a spar...