Falcon L 540 720 Instruction Manual - Installation

Manual is about: Professional Kitchen Ranges

Page of 9

Download

Print this page

Bookmark us

INSTALLATION

Drilling the Support surface and Fitting the Hood

The Hood can be fi tted directly to the underside of the Wall units (min. 650 mm above the cooker

top) with snap-on side supports, which are set up for a support panel thickness of between 15 mm

and 30 mm.

• Cut a fi tted opening in the bottom surface of the

wall unit, as shown.

• Remove the metal grease fi lters (see par. on

Maintenance).

• Disconnect the fi lter support by turning the

internal handles provided.

• Insert the hood until the side supports snap into

place.

• Lock in position by tightening the screws Vf

from underneath the hood.

375

Hood Type 54 72

L2 515 695

« ‹ Prev 2 3 4 5 6 7 8 Next › »

Summary of L 540 720

Page 1
Instruction manual gb.
Page 3
12 gb recommendations and suggestions installation • the manufacturer will not be held liable for any damages resulting from incorrect or improper installation. • the minimum safety distance between the cooker top and the extractor hood is 650 mm. • check that the mains voltage corresponds to that i...
Page 4: Characteristics
13 gb characteristics dimensions components ref. Q.Ty product components 1 1 hood body, complete with: controls, light, blower, filters 9 1 reducer flange ø 150-120 mm ref. Q.Ty installation components 12c 2 screws 2,9 x 6,5 q.Ty documentation 1 instruction manual 1 electric diagram l l1 400 370 175...
Page 5: Installation
14 gb installation drilling the support surface and fitting the hood the hood can be fi tted directly to the underside of the wall units (min. 650 mm above the cooker top) with snap-on side supports, which are set up for a support panel thickness of between 15 mm and 30 mm. • cut a fi tted opening i...
Page 6: Connections
15 gb • replace the fi lter support • screw the fi lter support using the 2 screws 12c (2,9 x 6 ,5) pro- vided. • replace the grease fi lters make sure that the handle is visible on the outside. Connections ducted version air exhaust system when installing the ducted version, connect the hood to the...
Page 7: Use
16 gb use control panel the hood can be switched on pushing directly onto the requested speed without fi rstly having to select 0/1 button. Key led functions l 0/1 light turns lighting on and off. T1 0/1 motor on first speed. When pressed for about 2 seconds the motor is switched off. T2 speed on se...
Page 8: Maintenance
17 gb remote control (optional) the appliance can be controlled using a remote control powered by a 1.5 v carbon-zinc alkaline batteries of the standard lr03-aaa type. • do not place the remote control near to heat sources. • used batteries must be disposed of in the proper manner. Maintenance greas...
Page 9: Lighting
18 gb a b activated charcoal fi lter (recirculation version) replacing the activated charcoal filter • the fi lter is not washable and cannot be regene- rated. It must be replaced when led s1 fl ashes or at least every 4 months. The alarm signal will only light up when the extractor motor is switche...