Fallowgate Limited BATRIBIKE User Manual - Batribike
5
8)
Fasten the front mudguard stays to the bottom of the fork legs, just
behind the axle with the screws
provided. Lift the mudguard to its
highest point in the slot on the top
of the fixing bracket & tighten all
three fasteners.
9)
Align the handlebars at 90
degrees to the front wheel &
tighten stud left loose in instruction
4.
Remove pedals from packaging &
screw into the correct side crank. The left hand crank has a left
hand thread & the pedal is marked with an ‘L’ stamped in the end.
The left pedal screws anti-clockwise & the right pedal (chain side)
screws in clockwise. Tighten both pedals.
10) SPEED RESTRICTOR WIRE, in
certain countries it is illegal to ride
on throttle alone at more than
20kmh. To de-restrict the speed to
be able to travel up to 15mph on
throttle disconnect the plug &
socket in the white wire located
under the battery lock. Fasten both
ends to the wiring loom to prevent
them catching in moving parts.
11) Remove the rest of the packaging
12) Inflate tyres to correct pressure (located on tyre wall)
13) When charging is complete replace battery & connect battery
cable, lock in position.
14) Insert seat to desired height & lock in position.
NOTE maximum height is marked on seat tube.
15) Congratulations you have built your
BATRIBIKE
®
Buzz. Please
read the user instructions for correct use of controls before you
ride.