FALMEC range hood Instruction Booklet - Warranty

14

order to avoid that oily or greasy substances affect the steel surfaces.

The ouside of the range hhod should be cleaned using a damp cloth and 

neutral liquid detergent or denatured alcohol. 

In case of fingerprint-less finish (fasteel) clean only with water and neutral 

soap using clean with a soft cloth, rinse and wipe dry thoroughly. Do not 

use products that contain abrasive substances, rough cloths or cloths spe-

cifically designed for cleaning steel. Using abrasive substances or rough 

cloths will inevitably damage the finish of steel. The steel surface will be 

irrevocably damaged if the instructions above are not complied with. Keep 

these instructions together with the instructions for use of your hood. 

The manufacturer accepts no liability for any damage caused by non-com-

pliance with the instructions above. 

4. CLEANING THE INSIDE OF THE APPLIANCE

The electrical parts or parts of the motor assembly inside the range hood 

must not be cleaned using liquids or solvents.

Do not use abrasive products. All the above operations must be performed 

after having disconnected the appliance from the mains power supply.

WARRANTY

M

The new equipment is covered by warranty. The warranty conditions are pro-

vided by the distributor.

The manufacturer is not liable for any inaccuracies in this booklet resulting 

from printing or transcription errors. The manufacturer reserves the right to 

modify its products as it considers necessary or in the interests of the user, 

without compromising their essential safety and operating characteristics.

ASSEMBLY INSTRUCTIONS

 (fig. O)

N

Step 1

- Remove the metal filters. 

Step 2

- Screw off the 6 screws (A), the 2 knurled pins (B), then remove the bottom 

part. For MASSIMO INSERT depth 23 ¾“ you must remove also the back 

screws (A’).

Step 3

- Insert the hood into the cabinet hole fix the hood using 10 screws for wood 

(C). 

On MASSIMO INSERT depth 23 ¾“ are available also side holes to fix the hood 

on the side panels of the cabinet.

Step 4

- Before making the electrical connections disconnect the power supply.

- Repeat step 1,2 to mount the botton part and the metal filters.