Famastil F-Power 9.6v Instruction Manual - page 27

27

ENGL

IS

H

FITTING AND REMOVING A DRILL BIT OR 

SCREWDRIVER BIT

This tool is fitted with a keyless chuck to 

allow for an easy exchange of bits.

  First remove the battery from the tool.

  Lock the tool by setting the 

direction 

selector (9)

 to the centre position.

01

02

03

04

05

PIC 1

PIC 2

OPEN

CLOSE

  Open the chuck by turning the front 

part with one hand while holding the 

rear part with the other (PIC 2).

  Insert the bit shank (13) into the chuck.

  Firmly tighten the chuck by turning the 

front part with one hand while holding 

the rear part with the other.

OPERATING INSTRUCTIONS

WARNING! Let the tool work at its own pace. Do not overload!

WARNING! Do not charge the battery at ambient temperatures

below 4 °C or above 40 °C. Recommended charging

temperature: approx. 24 °C.

CHARGING THE BATTERY

  The battery needs to be charged before first use and whenever it fails to produce 

sufficient power on jobs that were easily done before. When charging the battery for 

the first time, or after prolonged storage, it will only accept an 80% charge.

After several charge and discharge cycles, the battery will attain full capacity.

  The battery may become warm while charging. This is normal and does not indicate 

a problem.