Fanaway LED EVO1 Installation Operation & Maintenance - page 8
Fanaway LED EVO1 Installation Instructions
7 |
P a g e
V e r 1 . 0
Wiring requirement at the terminal block:
Switch the active wire out from the
rotary switch speed control “F” to the “L” terminal of the terminal block on the
mounting bracket.
Switch the active wire
out from wall controller “light” switch, to the “LA” terminal of the terminal block on the
mounting bracket
.
Supply Neutral to “N” terminal of the terminal block on the mounting bracket.
Earth to “
” terminal of the terminal block on the mounting bracket.
FINISH THE INSTALLATION
Connect the female plug (fan motor) and male plug (mounting bracket) together (1
– Fig.9).
Slide the canopy (No.3
– Fig. 1) onto the mounting bracket using the slotted holes. Align the other 2 holes and then
install the 2 other screws. Tighten all four screws firmly. Avoid damaging the electrical wiring prepared previously.
Fig. 8
Fig. 9