Fanimation Air Shadow FP820 Series Owner's Manual

Other manuals for Air Shadow FP820 Series: Specification Sheet
Manual is about: Mechanical Ceiling Fan

Summary of Air Shadow FP820 Series

  • Page 1

    Owner’s manual read and save these instructions model no. Fp820** net weight 9.14 kg (20 lbs) the air shadow ™ mechanical ceiling fan.

  • Page 2

    Table of contents unpacking instructions . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . 3 electrical and structural requirements . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . ...

  • Page 3

    This manual is designed to make it as easy as possible for you to assemble, install, operate, and maintain your ceiling fan unpacking instructions for your convenience, check-off each step. As each step is completed, place a check mark. This will ensure that all steps have been completed and will be...

  • Page 4

    Clevis pin setscrew (2) 4 electrical and structural requirements if your fan is to replace an existing light fixture, turn electricity off at the main fuse box at this time and remove the existing light fixture. Ceiling ceiling joists 2˝ x 4˝ outlet box figure 1 how to assemble your ceiling fan pin ...

  • Page 5

    5 how to assemble your ceiling fan (cont’d) 6. Route wires through opening in motor coupling cover. Position motor coupling cover on fan shown with open side facing down. (figure 2) 7. Route wires through opening in canopy. Position canopy on fan shown with open side facing up. (figure 3) 8. Reinsta...

  • Page 6

    6 how to hang your ceiling fan 1. Securely attach the hanger bracket to the outlet box using the outlet box screws and washers supplied with the outlet box (figure 2). Note: outlet box screws pass through slotted holes of the hanger bracket (figure 2). 2. Pull the electric wires in the outlet box do...

  • Page 7

    Blk-ant bl-ac in l wh-ac in n gray-reverse module blk-to motor l wh-to motor n grn or bare ground grn from hanger ball grn from bracket 120 vac supply (user supplied) blue-for light down 7 how to wire your ceiling fan - c28 remote control if you feel that you do not have enough electrical wiring kno...

  • Page 8

    8 installing the canopy housing 1. Screw in two threaded rods into the hanger bracket (figure 1a). Note: the threaded rods in the hanger bracket serve as guides for easier installation. 2. Securely attach the canopy housing to the hanger bracket using the external lockwashers and knurled knobs suppl...

  • Page 9

    9 trouble shooting ▲warning for your own safety turn off power at fuse box or circuit breaker before trouble shooting your fan. Trouble probable cause suggested remedy 1. Fan will not start 1. Fuse or circuit breaker blown. 2. Loose power line connections to the fan, or loose switch wire connections...

  • Page 10

    10 before discarding packaging materials, be certain all parts have been removed parts list model #fp820** ref. # description part # 1 hanger bracket assembly apg610bl 2 downrod/hanger ball assembly containing: adr1x6** 2a hanger ball assembly 2b downrod 2c hairpin clip 2d clevis pin 3 ceiling canop...

  • Page 11

    11 note: the illustration shown is not to scale or its actual confi guration may vary the air shadow fan fp820** exploded-view 4 1 figure 1 3 2a 7 5 2b 2c 2d 2 8 9 6.

  • Page 12

    10983 bennett parkway zionsville, in 46077 toll free (888) 567-2055 fax (866) 482-5215 outside u.S. Call (317) 733-4113 visit our website www.Fanimation.Com copyright 2008 fanimation 2008/05.