1. DL manuals
  2. Fanimation
  3. Fan
  4. Bayhill LB230VZ
  5. Owner's Manual

Fanimation Bayhill LB230VZ Owner's Manual

Manual is about: Fanimation Lauren Brooks LB230VZ Ceiling Fans: Owners Manual

Summary of Bayhill LB230VZ

  • Page 1

    Owner’s manual read and save these instructions the bayhill ™ collection lb250vz net weight 11.8 kg (26 lbs) lb230vz net weight 18.0 kg (39.7 lbs) lb270vz net weight 18.3 kg (40.4 lbs) models no. Lb250vz, lb230vz & lb270vz.

  • Page 2

    1. Limited lifetime motor warranty - if any part of your fan motor fails, due to a defect in materials or workmanship during the lifetime of the original purchaser, fanimation will provide the replacement part free of charge, when the defective fan is returned to our national service center. Proof o...

  • Page 3

    This manual is designed to make it as easy as possible for you to assemble, install, operate, and maintain your ceiling fan unpacking instructions for your convenience, check-off each step. As each step is completed, place a check mark. This will ensure that all steps have been completed and will be...

  • Page 4

    4 electrical and structural requirements your new ceiling fan will require a grounded electrical supply line of 120 volts ac, 60 hz, 15 amp circuit. The outlet box must be securely anchored and capable of withstanding a load of at least 50 lbs. Figure 1 depicts different structural configurations th...

  • Page 5

    5 how to assemble your ceiling fan (cont’d) 3. Loosen the two setscrews in the downrod support. Align the clevis pin holes in the downrod with the holes in the downrod support. Install the clevis pin and secure with the hairpin clip. (figure 2) be sure to push the straight leg of the hairpin clip th...

  • Page 6

    6 how to hang your ceiling fan ▲warning the fan must be hung with at least 7´ of clearance from floor to blades (figure 1) ▲warning the outlet box must be securely anchored and capable of withstanding a load of at least 50 lbs. Hanger bracket must seat fi rmly against outlet box. If the outlet box i...

  • Page 7

    7 how to wire and operate your c27 wall control if you feel that you do not have enough electrical wiring knowledge or experience, have your fan installed by a licensed electrician. ▲warning to avoid possible electrical shock, be sure electricity is turned off at the main fuse box before wiring. Not...

  • Page 8

    Fan blade figure 2 blade holder 8 installing the canopy housing 1. Loosen the two shoulder screws in the hanger bracket (figure 1a). 2. Securely attach the canopy housing over the shoulder screws. 3. Securely attach and tighten the canopy screw cover over the shoulder screws in the hanger bracket ut...

  • Page 9

    9 assembling and mounting the fan blades, & adapter/switch hsg figure 3 screw (2 per blade holder) 5. Attach assembled blades and blade holders to the motor hub using the provided screws.(figure 3) 6. Make sure the screws securing the blade holders to the motor hub are tight and that the blade holde...

  • Page 10

    10 maintenance periodic cleaning of your ceiling fan is the only maintenance that is needed. When cleaning, use only a soft brush or lint free cloth to avoid scratching the fi nish. Abrasive cleaning agents are not required and should be avoided to prevent damage to fi nish. Caution do not use water...

  • Page 11

    11 trouble shooting ▲warning for your own safety turn off power at fuse box or circuit breaker before trouble shooting your fan. Trouble probable cause suggested remedy 1. Fan will not start 1. Fuse or circuit breaker blown. 2. Loose power line connections to the fan, or loose switch wire connection...

  • Page 12

    12 before discarding packaging materials, be certain all parts have been removed parts list model #lb250vz ref. # description part # 1 hanger bracket assembly with shoulder screws (2) ap255 2 downrod/hanger ball assembly containing: adr1-6vz 2a hanger ball assembly 2b downrod 2c hairpin clip 2d clev...

  • Page 13

    The bayhill collection ™ lb250vz exploded-view 13 9 5 1 4 2a 2b 2c 2d 2 note: the illustration shown is not to scale or its actual confi guration may vary figure 1 10 8 11 7 6 3.

  • Page 14

    14 lklb230vz ceiling fan light kit installation instructions read and save these instructions weight: 9.5 lbs (4.31 kgs) 2. Assemble light kit and switch cup housing with lockwasher and nut provided. 1. Remove threaded plug from switch cup housing. 3. Connect white-to-white and blue-to-black wires. ...

  • Page 15

    15 lklb230vz ceiling fan light kit service parts before discarding packaging materials, be certain all parts have been removed how to order parts when ordering repair parts, always give the following information: • part number • part description • fan model number contact your retail store for repai...

  • Page 16

    16 lklb270vz ceiling fan light kit installation instructions read and save these instructions weight: 7.75 lbs (3.52 kgs) 2. Assemble light kit and switch cup housing with lockwasher and nut provided. 1. Remove threaded plug from switch cup housing. 3. Connect white-to-white and blue-to-black wires....

  • Page 17

    17 lklb270vz ceiling fan light kit service parts before discarding packaging materials, be certain all parts have been removed how to order parts when ordering repair parts, always give the following information: • part number • part description • fan model number contact your retail store for repai...

  • Page 18

    Lauren brooks™ & lauren brooks collection™ are trademarks of lauren brooks, inc. Copyright 2007 fanimation 2007/02 10983 bennett parkway zionsville, in 46077 (888) 567-2055 fax (866) 482-5215 outside u.S. Call (317) 733-4113 visit our website @ www.Fanimation.Com.