Model no. Fp3220** the draco ® ceiling fan draco™ fan chrome finish shown with plastic blade set draco™ fan glossy black finish shown with plastic blade set net weight 19.96 kg (44 lbs) owner’s manual read and save these instructions.
Table of contents unpacking instructions. . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . 3 electrical and structural requirements . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . ....
This manual is designed to make it as easy as possible for you to assemble, install, operate, and maintain your ceiling fan unpacking instructions for your convenience, check-off each step. As each step is completed, place a check mark. This will ensure that all steps have been completed and will be...
4 electrical and structural requirements your new ceiling fan will require a grounded electrical supply line of 120 volts ac, 60 hz, 15 amp circuit. The outlet box must be securely anchored and capable of withstanding a load of at least 50 lbs. Figure 1 depicts different structural configurations th...
5 how to assemble your ceiling fan (cont’d) note: you will be using either the 6˝ downrod supplied with your fan or an optional downrod purchased seperately. 4. Loosen the two setscrews in the downrod support. Align the clevis pin holes in the downrod with the holes in the downrod support. Install t...
6 how to hang your ceiling fan figure 1 floor ceiling no less than 7 ft ▲warning the fan must be hung with at least 7´ of clearance from floor to blades (figure 1) ▲warning the outlet box must be securely anchored and capable of withstanding a load of at least 50 lbs. Hanger bracket must seat fi rml...
7 how to wire your ceiling fan - c24 hand-held remote operating instructions - c24 hand-held remote 1. Operating & using remote transmitter (figure 3): install 9 volt battery (if not using for long periods of time, remove battery to prevent damage to transmitter). Store the transmitter away from exc...
8 assembling and mounting the fan blades 1. Lay blade medallion with the threaded posts facing up. 2. Position the plastic blade over the blade medallion with the threaded posts showing through the holes of the blade. (see insert for what side of blade that faces the medallion) 3. With a philips scr...
9 figure 1 3. Securely attach plugs from motor to sockets on downlight support plate assembly (figure 3) installing the lower housing assembly 1. Loosen three screws and remove one screw from support flange. (figure 1). Figure 2 figure 3 2. Securely attach the adapter plate to the support bracket an...
10 installing the lower housing assembly (cont’d) figure 4 figure 5 figure 6 4. Securely attach downlight socket plate assembly to the adapter plate by tightening four screws with spring washers ( 5 / 32 -32 x 8 mm) provided with the fan. (figure 4) 5. Install three candelabra bulbs (not included - ...
11 maintenance blade cleaning periodic cleaning of your new ceiling fan is the only maintenance that is needed. When cleaning, use only a soft brush or lint free cloth to avoid scratching the fi nish. Abrasive cleaning agents are not required and should be avoided to prevent damage to fi nish. Perio...
12 before discarding packaging materials, be certain all parts have been removed parts list model #fp3220** ref. # description part # 1 hanger bracket assembly apg510bl 2 downrod/hanger ball assembly containing: adr6 ¾¾ 2a hanger ball assembly 2b downrod 2c hairpin clip 2d clevis pin 3 ceiling canop...
13 note: the illustration shown is not to scale or its actual confi guration may vary the draco ® fp3220** exploded-view 4 1 figure 1 3 2a 8 12 ref 7 6 5 14 10 11 2b 2c 2d 2 13 12 reversing switch 9.
14 trouble shooting ▲warning for your own safety turn off power at fuse box or circuit breaker before trouble shooting your fan. Trouble probable cause suggested remedy 1. Fan will not start 1. Fuse or circuit breaker blown. 2. Loose power line connections to the fan, or loose switch wire connection...
10983 bennett parkway zionsville, in 46077 (888) 567-2055 fax (866) 482-5215 outside u.S. Call (317) 733-4113 visit our website www.Fanimation.Com copyright 2007 fanimation 2007/04.
