Owner’s manual read and save these instructions model no. Tf300** the edgewood ™ median ceiling fan net weight 7.67 kg (16.9 lbs).
1. Limited lifetime motor warranty - if any part of your fan motor fails, due to a defect in materials or workmanship during the lifetime of the original purchaser, fanimation will provide the replacement part free of charge, when the defective fan is returned to our national service center. Proof o...
This manual is designed to make it as easy as possible for you to assemble, install, operate, and maintain your ceiling fan unpacking instructions for your convenience, check-off each step. As each step is completed, place a check mark. This will ensure that all steps have been completed and will be...
4 electrical and structural requirements your new ceiling fan will require a grounded electrical supply line of 120 volts ac, 60 hz, 15 amp circuit. The outlet box must be securely anchored and capable of withstanding a load of at least 50 lbs. Figure 1 depicts different structural configurations th...
5 how to assemble your ceiling fan 1. Prior to assembly, set aside and save the hardware bags packed in the packing. 2. Remove the hanger ball by loosening the setscrew in the hanger ball until the ball falls freely down the downrod. (figure 1) remove the pin from the downrod, then remove the hanger...
6 how to hang your ceiling fan ▲warning the fan must be hung with at least 7´ of clearance from floor to blades (figure 1) ▲warning the outlet box must be securely anchored and capable of withstanding a load of at least 50 lbs. Hanger bracket must seat firmly against outlet box. If the outlet box is...
7 how to wire your ceiling fan if you feel that you do not have enough electrical wiring knowledge or experience, have your fan installed by a licensed electrician. 1. Connect the green grounding lead from the hanger ball and the green grounding lead from the hanger bracket to the supply grounding c...
Assembling and mounting the fan blades 1. Lay flat side of blade holder arm on a flat surface with the inside of the blade holder arm facing up. This is the side with the threaded posts and pitched foot. 2. Position the blade over the blade holder with the threaded posts showing. Make sure the botto...
R everse s witch i nformation s eason r otation d irection s witch p osition summer counter-clockwise right winter clockwise left 9 installing the switch cup assembly (cont’d) maintenance blade cleaning periodic cleaning of your new ceiling fan is the only maintenance that is needed. When cleaning, ...
10 before discarding packaging materials, be certain all parts have been removed parts list model #tf300** ¾¾ insert finish codes (refer to fan model number located on down rod support) how to order parts when ordering repair parts, always give the following information: • part number • part descrip...
11 note: the illustration shown is not to scale or its actual confi guration may vary tf300** median fan exploded-view figure 1 2a 2b 2c 2d 2 3 4 5 7 1 6 8 9.
12 trouble shooting trouble probable cause suggested remedy 1. Fan will not start 1. Fuse or circuit breaker blown. 2. Loose power line connections to the fan, or loose switch wire connections in the switch housing. 3. Reversing switch in neutral position. 1. Check main and branch circuit fuses or c...
Copyright 2007 fanimation 2007/02 10983 bennett parkway zionsville, in 46077 (888) 567-2055 fax (866) 482-5215 outside u.S. Call (317) 733-4113 visit our website @ www.Fanimation.Com.
