Fanimation Edgewood TF900 Series Owner's Manual - page 5
5
How to Assemble Your Ceiling Fan (cont’d)
1. Prior to assembly, set aside and save the hardware
bags packed in the packing.
2. Remove the Hanger Ball by loosening the setscrew
in the Hanger Ball until the ball falls freely down the
Downrod. (Figure 1) Remove the Pin from the Downrod,
then remove the Hanger Ball. Retain the Pin and Hanger
Ball for reinstallation in Step 7.
3. The fan comes with blue, black, white 80˝ wires and
safety cable. Separate & untwist the three wires and safety
cable. Route the wires through the Downrod.
NOTE: You will be using either the 4½˝ downrod
supplied with your fan or an optional down rod purchased
separately.
4. Loosen the two setscrews and hex nuts in the Downrod
Support. Screw Downrod into Coupler. Align the Clevis
Screw holes in the Downrod with the holes in the Downrod
Support. (Figure 2)
NOTE: The setscrews, hex nuts and rubber washers must
be properly installed as described earlier, or fan-wobble
could result.
5. Install the Clevis Screw, Rubber Washers and secure
with the Clevis Locknut and Hairpin Clip. (Figure 2) The
Clevis Locknut, Hairpin Clip and Washers must be properly
installed to prevent the Clevis Screw from working loose.
6. Route wires through Motor Coupling Cover and Canopy.
Position Canopy on fan shown with open side facing up.
(Figure 3)
7. Reinstall the Hanger Ball (Figure 3) on the Down rod
as follows. Route the three 80˝ wires through the Hanger
Ball. Position the Pin through the two holes in the Down
rod and align the Hanger Ball so the Pin is captured in the
groove in the top of the Hanger Ball. Pull the Hanger Ball
up tight against the pin. Securely tighten the setscrew
in the Hanger Ball. A loose setscrew could create fan
wobble.
8. The fan comes with blue, black, and white leads. Before
installing fan, measure up approximately 6-9 inches above
top of Downrod/Hanger Ball Assembly. Cut off excess wire
and strip back insulation ½˝ from each end of wires.
9. You have now completed the assembly of your new
ceiling fan. You can now proceed with the hanging and
the electrical wiring of your fan.
Figure 1
▲WARNING
It is critical that the clevis screw in the downrod support is
properly installed and the setscrews and nuts are securely
tightened. Failure to verify that the clevis screw, nuts, hairpin
clip and setscrews are properly installed could result in the fan
falling.
Downrod/
Hanger Ball
Assembly
Figure 3
Clevis Screw
w/Rubber
Washers (2),
Locknut
Hairpin
Clip
Ceiling
Canopy
Set Screw
w/Hex Nut
Rubber
Washer (2ea)
Pin
Setscrew
Hanger
Ball
Motor
Coupling
Cover
Figure 2
Rubber
Washer (2)