Owner’s manual read and save these instructions the edgewood ™ wet location ceiling fan net weight 14.56 kg (32.1 lbs) model no. Tf970ts.
1. Limited lifetime motor warranty - if any part of your fan motor fails, due to a defect in materials or workmanship during the lifetime of the original purchaser, fanimation will provide the replacement part free of charge, when the defective fan is returned to our national service center. Proof o...
This manual is designed to make it as easy as possible for you to assemble, install, operate, and maintain your ceiling fan unpacking instructions for your convenience, check-off each step. As each step is completed, place a check mark. This will ensure that all steps have been completed and will be...
4 electrical and structural requirements your new ceiling fan will require a grounded electrical supply line of 120 volts ac, 60 hz, 15 amp circuit. The outlet box must be securely anchored and capable of withstanding a load of at least 50 lbs. Figure 1 depicts different structural configurations th...
5 how to assemble your ceiling fan (cont’d) 1. Prior to assembly, set aside and save the hardware bags packed in the packing. 2. Remove the hanger ball by loosening the setscrew in the hanger ball until the ball falls freely down the downrod. (figure 1) remove the pin from the downrod, then remove t...
6 how to hang your ceiling fan 1. Securely attach the hanger bracket to the outlet box using the outlet box screws and washers supplied with the outlet box (figure 2). Note: outlet box screws pass through slotted holes of the hanger bracket (figure 2). 2. Pull the electric wires in the outlet box do...
7 how to wire your ceiling fan if you feel that you do not have enough electrical wiring knowledge or experience, have your fan installed by a licensed electrician. 1. Connect the green grounding lead from the hanger ball and the green grounding lead from the hanger bracket to the supply grounding c...
Assembling and mounting the fan blades 8 assembling and mounting the fan blades remove and discard the (rubber) motor “stops” by removing the five screws. (figure 1) blade & blade holder assembly: 1. Lay flat side of blade holder arm on a flat surface with the inside of the blade holder arm facing u...
9 installing the switch cup assembly (cont’d) maintenance blade cleaning periodic cleaning of your new ceiling fan is the only maintenance that is needed. When cleaning, use only a soft brush or lint free cloth to avoid scratching the fi nish. Abrasive cleaning agents are not required and should be ...
10 before discarding packaging materials, be certain all parts have been removed parts list model #tf970ts refer to fan model number located on down rod support how to order parts when ordering repair parts, always give the following information: • part number • part description • fan model number c...
11 note: the illustration shown is not to scale or its actual parts confi guration may vary tf970ts wet location fan exploded-view figure 1 2a 2b 2c 2d 2 3 4 5 6 7 8 1 9 10
12 trouble shooting trouble probable cause suggested remedy 1. Fan will not start 1. Fuse or circuit breaker blown. 2. Loose power line connections to the fan, or loose switch wire connections in the switch housing. 3. Reversing switch in neutral position. 1. Check main and branch circuit fuses or c...
Copyright 2007 fanimation 2007/11 10983 bennett parkway zionsville, in 46077 (888) 567-2055 fax (866) 482-5215 outside u.S. Call (317) 733-4113 visit our website @ www.Fanimation.Com.
