Owner’s manual read and save these instructions model no. Fp2700 series the evanesce ® ceiling fan suitable for use with solid state speed controls warning: support directly from building structure net weight 75 lbs (33.5 kg).
. Table of contents unpacking instructions. . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . 3 electrical and structural requirements . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . 4 wiring and control options . . ...
Light fan off low med hi 3 this manual is designed to make it as easy as possible for you to assemble, install, operate, and maintain your ceiling fan unpacking instructions for your convenience, check-off each step. As each step is completed, place a check mark. This will ensure that all steps have...
4 electrical and structural requirements wiring and control options please choose one of the following options and proceed to the page as indicated. 1. Fan (& optional light) remote control (c24), see page 5. 2. Fan (& optional light) wall control (c25), see page 6. 3. Optional light kit (lk27), see...
5 how to set and operate your c24 hand-held remote if you feel that you do not have enough electrical wiring knowledge or experience, have your fan installed by a licensed electrician. 1. Setting the code: the remote unit has 16 different code combinations. It may be necessary to test a couple frequ...
6 lig ht fan o ff lo w me d hi how to set and operate your c25 wireless wall control 1. Setting the code: the remote unit has 16 different code combinations. It may be necessary to test a couple frequency code settings to improve signal reception and/or eliminate interference from other remote contr...
Hanging the fan 7 figure 9 floor ceiling no less than 7 ft 35˝ long x 16½˝ wide 53˝ long x 34½˝ wide (w/light kits & shades) 18˝ note: prior to hanging your fan, set the frequency switches located on the receiver unit in the control box see pages 5 or 6. 1. Your fan is supplied with the following ha...
8 figures 10 & 10a 1. Position the wire up the chain or hanger rod. Attach the wire with supplied wire ties. 2. Feed the end or the lead wire through the provided hole next to the eye bolt in the hanger assembly. Guide the wire toward the center of the hanger system. 3. Feed the end or the lead wire...
Wiring your ceiling fan - hanger eye bolt mount figure 11 figures 11 & 11a 1. Attach the sheet metal strap to the ceiling junction box with the screws provided with the junction box. 2. Position the wire up the chain or hanger rod. Attach the wire with supplied wire ties. 3. Slide the canopy cover d...
10 installing the shades how to install your light kit - lk27 (optional) 1. Turn off power. 2. Remove rubber plug from screw hole. 3. Remove the “plain” side covers with the philips screwdriver. Save the screws. (figure 12) 4. Carefully connect the electrical connectors on the light kit to connector...
11 maintenance figure 14 how to change your light bulbs candelabra bulb 1. Turn off power. 2. Remove the faulty bulb(s). By gently, twisting counter- clockwise and pulling out the bulb (figure 14). 3. Install the bulb, twisting clockwise to seat the bulb. 4. Restore power. Periodic cleaning of your ...
12 ref. # description qty part # 1 fan motor assembly 1 ' 2 canopy assembly 1 p2702 3 control receiver unit (inside control housing) 1 p2704 4 canopy ceiling assembly 1 p2705 5 side cover 6 p2709 6 light kit † lk27 ¾¾ 7 wire nut 3 hdwfp2700 8 wire tie 8 9 flat washer 2 10 5˝ lag bolt 2 11 80˝ hangin...
Light fan off low med hi 13 note: the illustration shown is not to scale or its actual confi guration may vary. Wires partially removed for clarity. Parts illustration 7 6 11 13 14 9 10 16 5 4 3 2 the evansece ® fp2700 optional - sold separately 12 1 figure 15 15 8.
14 trouble shooting ▲warning for your own safety turn off power at fuse box or circuit breaker before trouble shooting your fan. Trouble probable cause suggested remedy 1. Fan will not start 1. Fuse or circuit breaker blown. 2. Loose power line connections to the fan, or loose switch wire connection...
10983 bennett parkway zionsville, in 46077 (888) 567-2055 fax (866) 482-5215 outside u.S. Call (317) 733-4113 visit our website @ www.Fanimation.Com copyright 2006 fanimation 2006/02.
