Fanimation FP5420OB Owner's Manual

Manual is about: Fanimation Celano FP5420PW Ceiling Fans: Owners Manual

Summary of FP5420OB

  • Page 1

    Model no. Fp5420pw the celano ™ ceiling fan net weight 9.07 kg (20.0 lbs) owner’s manual read and save these instructions.

  • Page 2

    1. Limited lifetime motor warranty - if any part of your fan motor fails, due to a defect in materials or workmanship during the lifetime of the original purchaser, fanimation will provide the replacement part free of charge, when the defective fan is returned to our national service center. Proof o...

  • Page 3

    This manual is designed to make it as easy as possible for you to assemble, install, operate, and maintain your ceiling fan unpacking instructions for your convenience, check-off each step. As each step is completed, place a check mark. This will ensure that all steps have been completed and will be...

  • Page 4

    4 electrical and structural requirements your new ceiling fan will require a grounded electrical supply line of 120 volts ac, 60 hz, 15 amp circuit. The outlet box must be securely anchored and capable of withstanding a load of at least 50 lbs. Figure 1 depicts different structural configurations th...

  • Page 5

    5 how to assemble your ceiling fan 1. Dis-assemble the upper housing cover by loosening three screws (fig 1a) and carefully twist-n-lift off the cover (fig 1b). 3. Re-assemble the upper housing cover by securing the cover as shown (figure 3) and do not over-tighten the screws. 2. Attach blades to th...

  • Page 6

    6 how to assemble your ceiling fan (cont’d) 6. Loosen the two setscrews in the downrod support. Align the clevis pin holes in the downrod with the holes in the downrod support. Install the clevis pin and secure with the hairpin clip. (figure 5) be sure to push the straight leg of the hairpin clip th...

  • Page 7

    How to hang your ceiling fan figure 1 floor no less than 7 ft 7 ▲warning the fan must be hung with at least 7´ of clearance from floor to blades (figure 1) ▲warning the outlet box must be securely anchored and capable of withstanding a load of at least 50 lbs. Hanger bracket must seat fi rmly agains...

  • Page 8

    8 how to wire your ceiling fan - c24 remote control operating instructions - c24 remote control 1. Operating & using remote transmitter (figure 3): install 9 volt battery (if not using for long periods of time, remove battery to prevent damage to transmitter). Store the transmitter away from excess ...

  • Page 9

    9 installing the canopy housing figure 1 3. Securely attach plugs from motor to sockets on downlight support plate assembly (figure 3) installing the light kit assembly 1. Loosen three screws and remove one screw from support flange. (figure 1). Figure 2 figure 3 2. Securely attach the adapter plate...

  • Page 10

    10 installing the light kit assembly (cont’d) figure 4 figure 5 figure 6 4. Securely attach downlight socket plate assembly to the adapter plate by tightening three screws provided with the fan. (figure 4) 5. Install three candelabra bulbs (not included - 40 watts max) in each of the sockets on the ...

  • Page 11

    11 installing the lower housing cover figure 4 figure 3 figure 1 2. Carefully dis-assemble the glass from support frame and indexing plate by removing three screws. (figure 2a) 3. Assemble the lower bowl housing onto the support frame and indexing plate by securing three screws, do not over-tighten....

  • Page 12

    Maintenance blade cleaning periodic cleaning of your new ceiling fan is the only maintenance that is needed. When cleaning, use only a soft brush or lint free cloth to avoid scratching the fi nish. Abrasive cleaning agents are not required and should be avoided to prevent damage to fi nish. Periodic...

  • Page 13

    13 trouble shooting ▲warning for your own safety turn off power at fuse box or circuit breaker before trouble shooting your fan. Trouble probable cause suggested remedy 1. Fan will not start 1. Fuse or circuit breaker blown. 2. Loose power line connections to the fan, or loose switch wire connection...

  • Page 14

    14 before discarding packaging materials, be certain all parts have been removed parts list model #fp5420pw ref. # description part # 1 hanger bracket assembly (apg610bl) with shoulder screws (2) ap255 2 downrod/hanger ball assembly containing: adr1-6pw 2a hanger ball assembly 2b downrod 2c hairpin ...

  • Page 15

    Note: the illustration shown is not to scale or its actual confi guration may vary the celano ™ fp5420pw exploded-view 4 1 figure 1 3 2a 8 7 10 11 6 5 13 14 15 12 2b 2c 2d 2 reversing switch 9 15.

  • Page 16

    10983 bennett parkway zionsville, in 46077 (888) 567-2055 fax (866) 482-5215 outside u.S. Call (317) 733-4113 visit our website www.Fanimation.Com copyright 2007 fanimation 2007/11.