Fanimation FP7410 Owner's Manual - page 8
8
Assembling and Mounting the Fan Blades and Switch Hsg
Blade & Blade Holder Assembly:
1. Lay the side of the blade holder on a flat surface with the
inside of the blade holder facing up.
2. Assemble the blade to the blade holder with the washer
screws with fiber washers. Make sure the bottom edge of
the blade is fully seated against the blade holder.
3. Tighten three screws, don’t over-tighten. (Figure 1)
4. Attach assembled blades and blade holders to the motor
hub using the provided screws & lock washers.(Figure 2)
5. Make sure the screws securing the blade holders to the
motor hub are tight and that the blade holders are properly
seated.
Housing Switch Cup/Adapter Assembly:
6. Disassemble the Housing Switch Cup/Adapter assembly
by removing three screws. (Figure 3)
7. Assemble the Adapter assembly on the Housing Support
bracket and tighten three screws. (Figure 4)
8. Securely attach the ‘color-matching‘ 9-pin switch
cup connector to wiring harness socket within Adapter
assembly. (Figure 4)
INSTALLATION NOTE
Do not connect fan blades until the fan is completely
installed. Installing the fan with blades assembled may
result in damage to the fan blades.
▲WARNING
To reduce the risk of personal injury, do not bend the
blade holders when installing, balancing the blades or
cleaning the fan. Do not insert foreign objects in between
the rotating blades.
Figure 2
Fan Blade
Screw
(2 per blade
holder)
Figure 1
Blade
Holder
Figure 4
Figure 3