Owner’s manual read and save these instructions model no. Fp7910ob the levon ™ 8-bladed ceiling fan net weight 12.0 kg (26.5 lbs).
1. Limited lifetime motor warranty - if any part of your fan motor fails, due to a defect in materials or workmanship during the lifetime of the original purchaser, fanimation will provide the replacement part free of charge, when the defective fan is returned to our national service center. Proof o...
This manual is designed to make it as easy as possible for you to assemble, install, operate, and maintain your ceiling fan unpacking instructions for your convenience, check-off each step. As each step is completed, place a check mark. This will ensure that all steps have been completed and will be...
4 electrical and structural requirements your new ceiling fan will require a grounded electrical supply line of 120 volts ac, 60 hz, 15 amp circuit. The outlet box must be securely anchored and capable of withstanding a load of at least 50 lbs. Figure 1 depicts different structural configurations th...
How to assemble your ceiling fan pin setscrew hanger ball figure 1 1. Remove the hanger ball by loosening the setscrew in the hanger ball until the ball falls freely down the downrod. (figure 1) remove the pin from the downrod, then remove the hanger ball. Retain the pin and hanger ball for reinstal...
Figure 2 junction box ceiling support cable hanger bracket ceiling ceiling joist wood member (2˝ x 4˝ approx.) figure 3 downrod/hanger ball assembly attach safety cable to ceiling support cable tab note: supply wires and fan wires omitted for clarity 6 how to hang your ceiling fan figure 1 floor cei...
7 how to wire your ceiling fan - pull chain if you feel that you do not have enough electrical wiring knowledge or experience, have your fan installed by a licensed electrician. 1. Connect the green grounding lead from the hanger ball and the green grounding lead from the hanger bracket to the suppl...
8 assembling and mounting the fan blades and switch hsg 1. Remove and discard the (rubber) motor “stops” by removing the screws. (figure 1) blade & blade holder assembly: 2. Lay the side of the blade holder on a flat surface with the inside of the blade holder facing up. 3. Assemble the blade to the...
9 maintenance periodic cleaning of your new ceiling fan is the only maintenance that is needed. When cleaning, use only a soft brush or lint free cloth to avoid scratching the fi nish. Abrasive cleaning agents are not required and should be avoided to prevent damage to fi nish. Caution do not use wa...
10 before discarding packaging materials, be certain all parts have been removed parts list model fp7910ob # t r a p n o it p ir c s e d # f e r b o 0 1 6 g p a y l b m e s s a t e k c a r b r e g n a h 1 2 downrod/hanger ball assembly containing: adr1-6ob 2a hanger ball assembly 2b downrod 2c clevi...
11 6 5 7 the levon ™ – fp7910ob exploded-view 4 8 1 3 2a 2b 2c 2d 2 note: the illustration shown is not to scale or its actual confi guration or fi nishes may vary figure 1 9.
12 trouble shooting ▲warning for your own safety turn off power at fuse box or circuit breaker before trouble shooting your fan. Trouble probable cause suggested remedy 1. Fan will not start 1. Fuse or circuit breaker blown. 2. Loose power line connections to the fan, or loose switch wire connection...
Copyright 2009 fanimation 2009/07 10983 bennett parkway zionsville, in 46077 toll free (888) 567-2055 fax (866) 482-5215 outside u.S. Call (317) 733-4113 visit our website @ www.Fanimation.Com.
