- DL manuals
- Fanimation
- Fan
- Michael David’s Adventure LB1820BL
- Owner's Manual
Fanimation Michael David’s Adventure LB1820BL Owner's Manual
Summary of Michael David’s Adventure LB1820BL
Page 1
Owner’s manual read and save these instructions model no. Lb1820bl michael david’s adventure ™ ceiling fan net weight of fan ass’y with light kit ass’y: 34 lbs (15.42 kg).
Page 2
1. Limited lifetime motor warranty - if any part of your fan motor fails, due to a defect in materials or workmanship during the lifetime of the original purchaser, fanimation will provide the replacement part free of charge, when the defective fan is returned to our national service center. Proof o...
Page 3
3 this manual is designed to make it as easy as possible for you to assemble, install, operate, and maintain your ceiling fan unpacking instructions for your convenience, check-off each step. As each step is completed, place a check mark. This will ensure that all steps have been completed and will ...
Page 4
4 electrical and structural requirements ceiling ceiling joists 2˝ x 4˝ outlet box figure 1 wiring and control options please choose one of the following options and proceed to the page as indicated. 1. Fan & light, 3-speed, reversable remote control (c22), see page 7. 2. Fan & light, 3-speed, rever...
Page 5
5 how to assemble your ceiling fan (cont'd) the clevis pin must go through the holes in the downrod support and the holes in the downrod. Be sure to push the straight leg of the hairpin clip through the hole near the end of the clevis pin until the curved portion of the hairpin clip snaps around the...
Page 6
6 how to hang your ceiling fan 1. Using the 3 ⁄ 8 ˝ x 2˝ lag bolt and flat washer, attach safety cable to ceiling joist or wood structural member. The lag bolt will pass through the flat washer, safety cable loop, the junction box and into the building structure (figure 2). You will first drill a ¼˝...
Page 7
7 how to wire and operate your c22 remote control if you feel that you do not have enough electrical wiring knowledge or experience, have your fan installed by a licensed electrician. Figure 1b figure 1a 9v battery remote transmitter unit detail receiver unit detail figure 2 fan motor unit bl-ac in ...
Page 8
8 how to wire and operate your c23 wall control if you feel that you do not have enough electrical wiring knowledge or experience, have your fan installed by a licensed electrician. Note: if fan or supply wires are different colors than indicated, have this unit installed by a qualifi ed electrician...
Page 9
9 figure 1a figure 1b note: supply wires and fan wires omitted for clarity. Note: this step is applicable after the neccessary wiring is completed. (see page 7 or 8) ▲warning to avoid possible fire or shock, make sure that the electrical wires are completely inside the canopy housing and not pinched...
Page 10
10 installing light kit assembly ▲warning to avoid fire or shock, follow all wiring instructions carefully. Any electrical work not described in these instructions should be done or approved by a licensed electrician. ▲warning turning off wall switch is not sufficent. To avoid possible electrical sh...
Page 11
11 installing light kit assembly (cont’d) figure 4 figure 5 5. Carefully push all wires back into cover switch housing of fan. Then fasten assembled cover switch housing/fi tter with two screws provided. (figure 4) 6. Install and secure four fitter shades as shown. (figure 5) 7. Install four 60 watt...
Page 12
12 before discarding packaging materials, be certain all parts have been removed parts list model #lb1820bl how to order parts when ordering repair parts, always give the following information: • part number • part description • fan model number contact your retail store for repair parts. Ref. # des...
Page 13
13 note: the illustration shown is not to scale or its actual confi guration may vary. Wires partially removed for clarity. Figure 1 michael david’s adventure ™ lb1820bl exploded-view 9 4 3 2 5 10 6 12 7 13 1 11 14 8.
Page 14
14 trouble shooting ▲warning for your own safety turn off power at fuse box or circuit breaker before trouble shooting your fan. Trouble probable cause suggested remedy 1. Fan will not start 1. Fuse or circuit breaker blown. 2. Loose power line connections to the fan, or loose switch wire connection...
Page 16
Copyright 2007 fanimation 2007/05 10983 bennett parkway zionsville, in 46077 toll free (888) 567-2055 fax (866) 482-5215 outside u.S. Call (317) 733-4113 visit our website @ www.Fanimation.Com lauren brooks™ & lauren brooks collection™ are trademarks of lauren brooks, inc..