Owner’s manual read and save these instructions model no. Fp240** the palisade ® ceiling fan standard & damp location models damp location model; top of fan is marked, “suitable for use in damp locations” net weight 21 kg (46 lbs).
. Table of contents 1. Limited lifetime motor warranty - if any part of your fan motor fails, due to a defect in materials or workmanship during the lifetime of the original purchaser, fanimation will provide the replacement part free of charge, when the defective fan is returned to our national ser...
3 this manual is designed to make it as easy as possible for you to assemble, install, operate, and maintain your ceiling fan unpacking instructions for your convenience, check-off each step. As each step is completed, place a check mark. This will ensure that all steps have been completed and will ...
Housing support extension pole figure 1 extension pole 4 electrical and structural requirements your new ceiling fan will require a grounded electrical supply line of 120 volts ac, 60 hz, 15 amp circuit. The outlet box must be securely anchored and capable of withstanding a load of at least 100 lbs....
5 assembling crossbar to the extension pole (cont’d) ¼ ˝ x 2 3 ⁄ 16 ˝ socket head bolts and locking nuts. Securely tighten both bolt and nut sets (figure 2). 5. Slide canopy over onto extension pole. 6. Route wires and safety cable though the hanger ball adapter assembly. (figure 3) 7. Assemble the ...
6 fan alignment and hanger bracket installation (cont’d) final fan assembly 1. Make sure the electrical supply wires, including the hanger bracket grounding wire and safety cable are pulled through the extension pole, between the hanger bracket and the junction box so that electrical connections can...
Final fan assembly (cont’d) 2. Using the styrofoam pad provided, position one motor at each end of the tube assembly. Securely attach plug from motor to socket on tube assembly. (figure 2) 3. Push assembled plug inside of tube assembly and slide end of motor into tube assembly. 4. Align holes of tub...
8 how to wire your ceiling fan if you feel that you do not have enough electrical wiring knowledge or experience, have your fan installed by a licensed electrician. 1. Run the blue, black and white fan wires through the wiring hole in the side of the hanger bracket to allow for electrical connection...
Off off hi lo off off hi lo how to wire your ceiling fan - c3 wall control operating instructions - c3 wall control if you feel that you do not have enough electrical wiring knowledge or experience, have your fan installed by a licensed electrician. Note: if fan or supply wires are different colors ...
10 installing the canopy housing 1. Screw in two threaded rods into the hanger bracket (figure 1a). Note: the threaded rods in the hanger bracket serves as guides for easier installation. 2. Securely attach the canopy housing to the hanger bracket using the external lockwashers and knurled knobs sup...
11 controlling air fl ow patterns reversing switch location figure 1a figure 2 side a side b figure 1b color code location color code location figure 2: side a reversing switch setting - with red dot blade arm set - with red dot side b reversing switch setting - with white dot blade arm set - with w...
12 maintenance blade cleaning periodic light dusting of the palm leaf and woven bamboo blades is recommended. A feather duster will work best. Avoid using water, cleansers, or harsh rags, which can warp and ruin the blades. Periodic cleaning of your new ceiling fan is the only maintenance that is ne...
13 trouble shooting ▲ warning for your own safety turn off power at fuse box or circuit breaker before trouble shooting your fan. Trouble probable cause suggested remedy 1. Fan will not start 1. Fuse or circuit breaker blown. 2. Loose power line connections to the fan, or loose switch wire connectio...
14 before discarding packaging materials, be certain all parts have been removed parts list ref. # description part # 1 hanger bracket assembly ahb2210 2 hanger ball adapter assembly ap2235 ¾¾ 4 extension pole (purchased separately) ep g – ¾¾ 5 canopy pg160 ¾¾ 7 horizontal tube assembly ata2215 ¾¾ 8...
14 note: the illustration shown is not to scale or its actual con fi guration may vary, wires omitted for clarity. Exploded-view side b side a 16 12 1 11 17 13 14 20 18 19 10 4 7 16 6 3 2 the palisade ® fp240** figure 1 5 8 8 9 21 12a 11 22 23 15.
Copyright 2007 fanimation 2007/05 10983 bennett parkway zionsville, in 46077 (888) 567-2055 fax (866) 482-5215 outside u.S. (317) 733-4113 visit our website www.Fanimation.Com.
