Owner’s manual read and save these instructions model no. Fp1820** the sandella ® ceiling fan sandella ® fan shown with traditional blade holders sandella ® fan shown with wooden blade holders weight 34 lbs. Standard & damp location models @ @ damp location model; top of fan is marked, “suitable for...
1. Limited lifetime motor warranty - if any part of your fan motor fails, due to a defect in materials or workmanship during the lifetime of the original purchaser, fanimation will provide the replacement part free of charge, when the defective fan is returned to our national service center. Proof o...
Rev u/l d/l fan off off on low med hi 3 this manual is designed to make it as easy as possible for you to assemble, install, operate, and maintain your ceiling fan unpacking instructions for your convenience, check-off each step. As each step is completed, place a check mark. This will ensure that a...
4 electrical and structural requirements ceiling ceiling joists 2˝ x 4˝ outlet box figure 1 your new ceiling fan will require a grounded electrical supply line of 120 volts ac, 60 hz, 15 amp circuit. The outlet box must be securely anchored and capable of withstanding a load of at least 50 lbs. Figu...
5 how to assemble your ceiling fan (cont'd) the clevis pin must go through the holes in the downrod support and the holes in the downrod. Be sure to push the straight leg of the hairpin clip through the hole near the end of the clevis pin until the curved portion of the hairpin clip snaps around the...
6 how to hang your ceiling fan 1. Using the 3 ⁄ 8 ˝ x 2˝ lag bolt and flat washer, attach safety cable to ceiling joist or wood structural member. The lag bolt will pass through the flat washer, safety cable loop, the junction box and into the building structure (figure 6). You will first drill a ¼˝...
7 how to wire and operate your c22 remote control if you feel that you do not have enough electrical wiring knowledge or experience, have your fan installed by a licensed electrician. Figure 8b figure 8a 9v battery remote transmitter unit detail receiver unit detail figure 9 fan motor unit bl-ac in ...
8 how to wire and operate your c23 wall control if you feel that you do not have enough electrical wiring knowledge or experience, have your fan installed by a licensed electrician. Note: if fan or supply wires are different colors than indicated, have this unit installed by a qualifi ed electrician...
9 installing the canopy housing 1. Screw in two threaded rods into the hanger bracket (figure 12a). Note: the threaded rods in the hanger bracket serves as guides for easier installation. 2. Securely attach the canopy housing to the hanger bracket using the external lockwashers and knurled knobs sup...
10 mounting the cover switch housing maintenance blade cleaning periodic cleaning of your new ceiling fan is the only maintenance that is needed. When cleaning, use only a soft brush or lint free cloth to avoid scratching the fi nish. Abrasive cleaning agents are not required and should be avoided t...
11 trouble shooting ▲warning for your own safety turn off power at fuse box or circuit breaker before trouble shooting your fan. Trouble probable cause suggested remedy 1. Fan will not start 1. Fuse or circuit breaker blown. 2. Loose power line connections to the fan, or loose switch wire connection...
12 before discarding packaging materials, be certain all parts have been removed parts list ref. No. Description part # 1 hanger bracket assembly apg510bl 3 ceiling canopy pg160 ¾¾ hardware bag containing: hdwfp1830 ¾¾ 4 5/32˝ threaded rods (2) 5 5/32˝ external lockwashers (2) 6 knurled knobs (2) 10...
Rev u/l d/l fan off off on low med hi 13 note: the illustration shown is not to scale or its actual confi guration may vary. Wires partially removed for clarity. Exploded-view side b side a 21 20 23 24 9 8 19 11 12 15 22 14 7 6 4 5 3 16 2 1 ground wire (green) ground wire (green) the sandella ® fp18...
Copyright 2007 fanimation 2007/01 10983 bennett parkway zionsville, in 46077 (888) 567-2055 fax (866) 482-5215 outside u.S. Call (317) 773-4113 visit our website @ www.Fanimation.Com.
