Fanimation TF610** Owner's Manual

Manual is about: The Edgewood Decorative Deluxe Ceiling Fan

Summary of TF610**

  • Page 1

    Owner’s manual read and save these instructions model no. Tf610**, tf710** the edgewood ™ decorative / deluxe ceiling fan model tf610; net weight 9.61 kg (21.2 lbs) model tf710; net weight 13.51 kg (29.8 lbs).

  • Page 2: Limited Lifetime Warranty

    1. Limited lifetime motor warranty - if any part of your fan motor fails, due to a defect in materials or workmanship during the lifetime of the original purchaser, fanimation will provide the replacement part free of charge, when the defective fan is returned to our national service center. Proof o...

  • Page 3: Unpacking Instructions

    This manual is designed to make it as easy as possible for you to assemble, install, operate, and maintain your ceiling fan unpacking instructions for your convenience, check-off each step. As each step is completed, place a check mark. This will ensure that all steps have been completed and will be...

  • Page 4

    4 electrical and structural requirements your new ceiling fan will require a grounded electrical supply line of 120 volts ac, 60 hz, 15 amp circuit. The outlet box must be securely anchored and capable of withstanding a load of at least 50 lbs. Figure 1 depicts different structural configurations th...

  • Page 5

    5 how to assemble your ceiling fan figure 1 downrod/ hanger ball assembly figure 2 downrod support pin setscrew hanger ball figure 3 hairpin clip set screw w/hex nut rubber washer (2ea) 1. Prior to assembly, set aside and save the hardware bags packed in the packing. Remove the hanger ball by loosen...

  • Page 6

    6 how to assemble your ceiling fan (cont’d) figure 4 figure 5 figure 6 ceiling canopy motor coupling cover canopy screw cover 5. Reinstall the hanger ball on the downrod as follows. Route the three 80 in. Wires through the hanger ball. Position the pin through the two holes in the downrod and align ...

  • Page 7: How to Hang Your Ceiling Fan

    7 how to hang your ceiling fan figure 7 main fuse box figure 10 figure 9 outlet box hanger bracket outlet box hanger bracket screw (2) supplied with outlet box tab downrod/hanger ball assembly figure 8 floor ceiling no less than 7 ft note: if you are not sure if the outlet box is grounded, contact a...

  • Page 8: How to Wire Your Ceiling Fan

    8 installing the canopy housing figure 14a how to wire your ceiling fan 1. Connect the green grounding lead from the hanger ball and the green grounding lead from the hanger bracket to the supply grounding conductor (this may be a bare wire or wire with green colored insulation). Securely connect wi...

  • Page 9

    9 installing the switch cup assembly 1. Securely attach the 9-pin connector from motor assembly to wiring harness socket within switch cup assembly.(figure 17) figure 17 x 10 1/4-20 x 14mm phillips screws hardware used: assembling and mounting the fan blades do not connect fan blades until the fan i...

  • Page 10: Maintenance

    10 installing the switch cup assembly (cont’d) maintenance blade cleaning periodic cleaning of your new ceiling fan is the only maintenance that is needed. When cleaning, use only a soft brush or lint free cloth to avoid scratching the finish. Abrasive cleaning agents are not required and should be ...

  • Page 11

    11 before discarding packaging materials, be certain all parts have been removed parts list models #tf610** / 710** insert finish codes (refer to fan model number located on down rod support) how to order parts when ordering repair parts, always give the following information: • part number • part d...

  • Page 12: Tf610** Decorative Fan

    12 note: y. R a v y a m n o it a r u g if n o c l a u t c a s ti r o e l a c s o t t o n s i n w o h s n o it a rt s u ll i e h t figure 1 3 4 5 7 1 2 6 8 10 9 tf610** decorative fan tf710** deluxe fan exploded-view.

  • Page 13: Trouble Shooting

    13 trouble shooting trouble probable cause suggested remedy 1. Fan will not start 1. Fuse or circuit breaker blown. 2. Loose power line connections to the fan, or loose switch wire connections in the switch housing. 3. Reversing switch in neutral position. 1. Check main and branch circuit fuses or c...

  • Page 14

    Copyright 2010 fanimation 2010/10 10983 bennett parkway zionsville, in 46077 (888) 567-2055 fax (866) 482-5215 outside u.S. Call (317) 773-4113 visit our website @ www.Fanimation.Com.

  • Page 15: Manual Del Propietario

    Manual del propietario lea y guarde estas instrucciones modelo n.º tf610**, tf710** the edgewood ™ ventilador de techo decorativo/de lujo modelo tf610; peso neto 9.61 kg (21.2 lbs) modelo tf710; peso neto 13.51 kg (29.8 lbs).

  • Page 16

    GarantÍa limitada de por vida del motor - si se produjera una falla en alguna de las partes del motor de su ventilador debido 1. A un defecto en los materiales o en la fabricación durante el tiempo de vida del comprador original, fanimation proporcionará la pieza de repuesto sin cargo una vez que el...

  • Page 17: Materiales

    17 juego de soporte de aspas bolsa de accesorios unidad del barral/de la semiesfera capuchón de techo • unidad del motor del ventilador unidad del motor del ventilador • caja del interruptor caja del interruptor • unidad del soporte de suspensión • unidad del barral/de la semiesfera • capuchón de te...

  • Page 18

    18 requisitos eléctricos y estructurales techo vigas del techo 2˝ x 4˝ caja de distribución eléctrica figura 1 advertencia a fin de evitar incendios o descargas eléctricas, siga con cuidado todas las instrucciones de instalación eléctrica. Cualquier trabajo eléctrico que no se describa en estas inst...

  • Page 19

    19 figura 1 unidad del barral/de la semiesfera figura 2 pasador figura 3 pasador de horquilla 1. Antes de realizar el ensamblaje, separe y guarde las bolsas de accesorios en el empaque. Afloje el tornillo de fijación de la semiesfera para lograr que ésta pueda desplazarse libremente por el barral. R...

  • Page 20: (Cont.)

    20 cómo ensamblar el ventilador de techo (cont.) figura 4 figura 5 figura 6 capuchón de techo cubierta de unión del motor la cubierta del tornillo de la base 5. Vuelva a colocar la semiesfera en el barral como se indica a continuación. Pase los tres cables de 2.03 m (80˝) a través de la semiesfera. ...

  • Page 21

    21 figura 7 figura 10 figura 9 figura 8 2. Levante cuidadosamente el ventilador y coloque el ensamble de la bola para colgar/varilla en la abrazadera para colgar que acaba de fijar a la caja de salida. Asegúrese de que la ranura de la bola esté alineada con la lengüeta de la abrazadera para colgar. ...

  • Page 22

    22 instalación de la cubierta del capuchón figura 14a nota: este paso se debe realizar luego de completar la 1. Conecte el conductor verde con conexión a tierra de la bola para colgar y el conductor verde con conexión a tierra de la abrazadera para colgar al conductor de suministro con conexión a ti...

  • Page 23

    23 instalación de la caja del interruptor 1. Fije firmemente el conector de 9 pasadores de la unidad del motor al enchufe del mazo de cables dentro de la unidad del adaptador del interruptor. (figura 17) figura 17 x 10 no conecte las aspas hasta que el ventilador esté totalmente instalado. Instalar ...

  • Page 24: Mantenimiento

    24 instalación de la caja del interruptor (cont.) instrucciones de funcionamiento - cadena de encendido/apagado 1. Vuelva a conectar la corriente eléctrica en la caja de distribución eléctrica mediante la conexión de la electricidad en la caja de fusibles principal. (figura 19) 3. Si desea que el fl...

  • Page 25: Lista De Piezas

    25 modelos n.° tf610** / 710** n.° de ref. Descripción tf710 pieza # n.° adr1-45** adr1-45** apgac110rbl appac1101** appac1101** p70055** p70055** cubierta de unión del motor ap1115** ap1115** p061001** p071002** ama0610** ama0710** ap60032** ap70032** p072101** p071001** 10 1 2 3 4 5 6 7 9 8 hdwtf6...

  • Page 26

    26 figura 1 3 4 5 7 1 2 6 8 10 9 ventilador de techo decorativo tf610** ventilador de techo de lujo tf710** despiece nota: la ilustración que se muestra no está hecha a escala y su configuración real puede variar..

  • Page 27: Solución De Problemas

    27 solución de problemas problema causa posible solución sugerida 1. El ventilador no arranca 1. El fusible o el disyuntor están fundidos. 2. Las conexiones eléctricas del ventilador o del interruptor en la caja del interruptor están flojas. 3. El conmutador inversor se encuentra en posición neutra....

  • Page 28

    Copyright 2010 fanimation 2010/10 10983 bennett parkway zionsville, in 46077 llame sin cargo al (888) 567-2055 fax (866) 482-5215 desde fuera de los ee.Uu. Llame al (317) 733-4113 visite nuestro sitio web en www.Fanimation.Com.