- DL manuals
- Fanimation
- Fan
- The Caruso FP7000 Series
- Owner's Manual
Fanimation The Caruso FP7000 Series Owner's Manual
Summary of The Caruso FP7000 Series
Page 1
Owner’s manual read and save these instructions model no. Fp7000** the caruso ® ceiling fan * damp location model; top of fan is marked, “suitable for use in damp locations” net weight (without blades): 60 lbs (27.22kgs) *select finish.
Page 2
. Table of contents 1. Limited lifetime motor warranty - if any part of your fan motor fails, due to a defect in materials or workmanship during the lifetime of the original purchaser, fanimation will provide the replacement part free of charge, when the defective fan is returned to our national ser...
Page 3
3 this manual is designed to make it as easy as possible for you to assemble, install, operate, and maintain your ceiling fan unpacking instructions for your convenience, check-off each step. As each step is completed, place a check mark. This will ensure that all steps have been completed and will ...
Page 4
4 electrical and structural requirements your new ceiling fan will require a grounded electrical supply line of 120vac, 60 hz, 15 amp circuit. The outlet box must be securely anchored and capable of withstanding a load of at least 100 lbs. Figure 1 depicts different structural con fi gurations that ...
Page 5
5 fan alignment and hanger bracket installation (cont’d) 4. Position the bottom end of the downrod inside the housing support located at the center of the support bar assembly. It may be necessary to loosen the two screws that go through the crossbar assembly if the downrod does not slide into the h...
Page 6
6 assembling and hanging the ceiling fan ▲ warning to avoid possible fire or shock, make sure that the electrical wires are completely inside the tube assembly and not pinched between the motor assembly and the tube assembly. Figure 4 figure 2 2. Securely attach plug from motor to socket on support ...
Page 7
Assembling and hanging the ceiling fan (cont’d) 7 figure 6 downrod/hanger ball assembly attach safety cable to ceiling support cable tab ▲ warning failure to seat tab in groove could cause damage to electrical wires and possible shock or fire hazard. ▲ warning to avoid possible shock, do not pinch w...
Page 8
8 how to wire your ceiling fan if you feel that you do not have enough electrical wiring knowledge or experience, have your fan installed by a licensed electrician. 1. Run the blue, black and white fan wires through the wiring hole in the side of the hanger bracket to allow for electrical connection...
Page 9
Off off hi lo how to wire your ceiling fan - c3-ca wall control operating instructions - c3-ca wall control if you feel that you do not have enough electrical wiring knowledge or experience, have your fan installed by a licensed electrician. Note: if fan or supply wires are different colors than ind...
Page 10
Fan blade figure 2 blade holder blade cover figure 1 10 installing the canopy housing 1. Screw in two threaded rods into the hanger bracket (figure 1a). Note: the threaded rods in the hanger bracket serves as guides for easier installation. 2. Securely attach the canopy housing to the hanger bracket...
Page 11
11 housing switch cup / adapter plate assembly figure 2 figure 1b figure 1a housing switch cup/adapter assembly: 1. Disassemble the housing switch cup/adapter assembly by removing three screws. (figure 1a) 2. Loosen two screws and remove one screw from housing support bracket. 3. Assemble the adapte...
Page 12
Tighten nut after setting angle figure 2 12 adjusting and setting the motor head angles note: this step is applicable after the necessary fan assembling, hanging and wiring is completed. 1. Remove knee caps from both side of each knee joints by twisting counter-clockwise. Figure 1 shows the angle ti...
Page 13
13 downrod / blade lengths vs motor head angle speci fi cations 15° b a 15° vertical vertical 30° 30° 45° 45° 60° 60° net hanging weight (fan only): 60 lbs dimensions shown in feet-inches dimensions shown in inches caruso ® ceiling / downrod specs chart motor tilt angle 18 ˝ blades 20 ˝ blades 22 ˝ ...
Page 14
14 maintenance blade cleaning periodic light dusting of the palm leaf and woven bamboo blades is recommended. A feather duster will work best. Avoid using water, cleansers, or harsh rags, which can warp and ruin the blades. Periodic cleaning of your new ceiling fan is the only maintenance that is ne...
Page 15
15 trouble shooting ▲ warning for your own safety turn off power at fuse box or circuit breaker before trouble shooting your fan. Trouble probable cause suggested remedy 1. Fan will not start 1. Fuse or circuit breaker blown. 2. Loose power line connections to the fan, or loose switch wire connectio...
Page 16
16 before discarding packaging materials, be certain all parts have been removed parts list ref. # description part # 1 hanger bracket assembly ahb700020bl 2 downrod/hanger ball assembly adr1-24** 3 ceiling canopy pg165** 4 support bar assembly ap700012** 5 trad.Blade holder (white dot) (set of 5) a...
Page 17
17 note: the illustration shown is not to scale or its actual con fi guration may vary, wires omitted for clarity. Exploded-view 2 4 11 10 3 6 7 5 7 9 8 the caruso ® fp7000** 1.
Page 18
Copyright 2008 fanimation 2008/06 10983 bennett parkway zionsville, in 46077 toll free (888) 567-2055 fax (866) 482-5215 outside u.S. (317) 733-4113 visit our website www.Fanimation.Com.