Owner’s manual read and save these instructions model no. Fp920 the torrento ® pedestal fan net weight 75 lbs. Wet location model.
1. Limited lifetime motor warranty - if any part of your fan motor fails, due to a defect in materials or workmanship during the lifetime of the original purchaser, fanimation will provide the replacement part free of charge, when the defective fan is returned to our national service center. Proof o...
3 unpacking instructions for your convenience, check-off each step. As each step is completed, place a check mark. This will ensure that all steps have been completed and will be helpful in fi nding your place should you be interrupted. Note: if you are uncertain of part description, refer to explod...
4 electrical requirements how to assemble your pedestal fan figure 1 figure 2 cover base connection 2¾˝ support shaft your new pedestal fan will require a grounded electrical supply line of 120 volts ac, 60 hz, 15 amp circuit. Use only on gfci protected receptacles. Do not use an extension cord! The...
Set screw (3) cover base connection base assembly support shaft 5 how to assemble your pedestal fan (cont’d) figure 3 filigree socket head screws with lockwashers & locknuts (9 places) base assembly filigree (3) support shaft filigree base screws, flatwashers & lockwashers (3 places) figure 4 figure...
6 how to assemble your pedestal fan (cont’d) screw (4) figure 8 fp920 – torrento ® ▲warning to avoid possible shock, do not pinch wires between the fan motor assembly and control housing support unit. 9. Securely attach the 4-pin connector between the fan motor unit to the control housing support as...
7 mounting the fan blades figure 2 figure 3 socket-head screw with lockwasher (2 per blade holder) blade holder cover blade holder arm figure 1 fp920 – torrento ® 2. Lay flat side of blade holder arm on a flat surface with the inside of the blade holder arm facing up. This is the side with the threa...
8 mounting fan base to floor fp920 – torrento ® concrete deck or porch note: minimum concrete thickness to be 5 inches thick. 1. Attaching fan to concrete will require power-hammer drill and concrete drill bit. Pre-drill three pilot holes, 2¾˝ deep using ⅝˝ drill bit. 2. Attach base to surface using...
9 fp920 – torrento ® maintenance periodic cleaning of your new pedestal fan is the only maintenance that is needed. When cleaning, use only a soft brush or lint free cloth to avoid scratching the fi nish. Abrasive cleaning agents are not required and should be avoided to prevent damage to fi nish. C...
10 before discarding packaging materials, be certain all parts have been removed parts list model #fp920 ¾¾ insert finish codes (refer to fan model number located on top of fan motor housing) ref. # description part # 1 fan motor/housing assembly ama920** 2 control housing support assembly ap9265** ...
11 note: the illustration shown is not to scale or its actual confi guration may vary. Wires partially removed for clarity. Blades are not included with this fan. The torrento ® fp920 exploded-view 1 figure 1 2 4 9 6 7 8 3 5 fp920 – torrento ®.
12 trouble shooting trouble probable cause suggested remedy 1. Fan will not start 1. Fuse or circuit breaker blown. 2. Loose power line connections to the fan, or loose switch wire connections in the switch housing. 3. Reversing switch in neutral position. 1. Check main and branch circuit fuses or c...
Fp920 – torrento ®.
Copyright 2007 fanimation, inc. 2007/10 10983 bennett parkway zionsville, in 46077 (888) 567-2055 fax (866) 482-5215 outside u.S. Call (317) 733-4113 visit our website @ www.Fanimation.Com fp920 – torrento ®.
