Fanstel ST218B Owner's Manual - page 13
Page 10
1. While talking on the handset, press the Speaker button to activate the speakerphone.
The call can now be heard from the speakerphone.
2. While talking on the speakerphone, simply lift up the handset and the call will be
transferred to the handset and will no longer be heard on the speakerphone.
3. Hang up the handset. Hanging up the handset will not disconnect the call when the
Speakerphone is activated. You have to press the Speaker or the Goodbye button
to disconnect the call.
4. If the speakerphone is not activated, simply hang up the handset and the call will be
disconnected.
Switching Between the Headset and the Speakerphone
To switch between a call from the headset to the speakerphone during a conversation:
1. While talking on the Headset, press the Speaker button to activate the
speakerphone. The call can now be heard from the speakerphone.
2. Press
the
ÃHeadset
button if you wish to activate the headset.
3. When you are finished with the conversation, press the Goodbye button, and the call
will be disconnected.
Switching Between the Handset and the Headset
To switch a call between the handset and the speakerphone during a conversation:
1. While talking on the handset, press the ÃHeadset button to activate the headset.
The call can now be heard from the headset.
2. Press
the
ÃHeadset
button again if you wish to switch back to the handset.
3. If you are using the headset, press the ÃHeadset button or the Goodbye button to
end a call.
4. If you are using the handset, simply hang up the handset to end a call.
Redialing
You can redial the last number you called with just one touch of the Redial button. This
lets you easily redial the same number again if the line was busy.
1. Pick up the handset or press the Speaker button and listen for a dial tone.
2. Press
the
Redial
button and the last number you dialed will be shown on the display
and will be automatically dialed.
Accessing Outside Lines
If you need to dial an outside line access code to access outside lines, you should enter
the outside line access code during “Installation” procedures. If not, you may begin
entering of outside line access code by pressing the Menu button.
Outside line access code is dialed automatically before any number with 7 or more digits
stored in caller ID memories, directory, or memory buttons.