Fantasea Blue Ray Tray Instruction Manual - page 4
4
Fantasea Blue Ray Tray Instruction Manual
At the same time, all housing support legs must be in contact with the tray stopper in
order for the housing to remain within a fixed position on the tray.
Therefore, glide the housing with the mounting screw attached to it towards the right
side of the tray, till the most right housing support leg is about to reach the right end
of the stopper.
g.
Tighten the tray mounting screw to the camera housing.
h.
Glide the tray stopper towards the support legs of the housing. If the stopper is
positioned behind the support legs, move it forward towards the legs. If it is positioned
in front of them, move it backwards. Note that in order for the housing to remain
within a fixed position on the tray, it is important that the tray stopper is pushed
against the housing support legs. Therefore, the stopper should be positioned as close
as possible to the legs, allowing for maximum friction.
i.
Once the tray stopper has been properly positioned, tighten the two stopper screws at
the bottom of the tray using a screwdriver.
j.
The instructions above are relevant for almost all compact camera housings. In case
you own a camera housing that cannot be mounted on the tray following the
instructions provided above, please contact us at
info@fantasea.com
for any special
parts that might be required in order to mount your housing on the tray.
2.
Mounting an Ikelite Camera Housing on the Blue Ray Tray
a.
Prior to mounting an Ikelite camera housing on the tray, the tray stopper and
mounting screw should be removed from the tray.
i.
Removing the Stopper- Unscrew the two screws at the bottom of the tray
stopper using a screwdriver, and then remove the stopper from the tray.
ii.
Removing the Mounting Screw- Glide the mounting screw all the way to the left
or right ends of the slot it is installed through. Unscrew the mounting screw
through the thread featured at the ends of this slot
(image #2)
.
In order to avoid
causing any damage to the threads of the screw or tray, make sure to hold the
mounting screw at a 90 degrees vertical angle when unscrewing it.
Image #2