Fantasea F580EX Mark II Instruction manual - page 10
10
MOUNTING THE SPEEDLIGHT IN THE HOUSING
Since the Fantasea F580EX Mark II Flash Housing was specifically designed for the Canon 580EX Mark
II Speedlight, insertion is a simple matter of placing the flash into the housing. Make sure the flash is
properly aligned and that it sits perfectly flat. There are no screws or mounts to worry about or any other
alignments once the flash is properly inserted.
Set the flashlight in an upright position. Slide the flashlight all the way into the hot-shoe of the housing until
it stops.
Notes:
1. It is recommended first to attach the flash to the camera's
hot shoe to determine if it is functioning properly.
2. Once this is determined, insert both into their respective
housings.
S
LIDE THE
F
LASHLIGHT INTO THE
G
UIDE
Turn the lock ring follow the direction “LOCK”. Take care not to excessively tighten the screw. Note: If you
find that control levers do not locate properly with the buttons, please check again that the flashlight is
properly seated to the limit of the guide rail.