Fantasea FE 330 Manual - Note!
Taking up Main Dial, slide the camera into the body along the guide rail inside the bezel [Figure 6].
Make sure the camera body reaches the limit and test the function of the
ON
/
OF BUTTONS
on the body
of the housing.
F
IGURE
6:
S
LIDING
C
AMERA INTO
B
ODY
A
LONG
G
UIDE
R
AIL
[2
GRAPHICS
]
Note!
If you find that the control levers do not articulate
properly with the camera buttons, please check again that
the camera is properly seated to the limit of the guide rail.
Never use force when placing the camera in the housing.
Slide the hot shoe insert card into the hot shoe [Figure 7].
F
IGURE
7:
H
OT SHOE
I
NSERT
C
ARD INTO
H
OT SHOE
Close Housing
1. Place housing back over front and align the complete mating surface of the housing and
the gasket, forming a proper seal.
2. Ensure that the pressure release plug is pulled all the way out while closing, otherwise the
air cannot escape.
3. Squeeze the lid closed all the way, you will hear the hiss of air being expelled.
4. Screw home the pressure release plug; you need not excessively tighten this plug. The
seal is made by the internal O-rings. The O-ring on the underside of the plug is just to
keep out dirt and other debris. Plug is shown in Figure 8 below in the lower right hand
corner [metallic color].
12