Fantasea Line UMG-02 Instruction Manual - page 2
2
UMG-02 LCD Magnifier Instruction Manual 20170528
INSTRUCTIONS FOR USE
1. Install the UMG-02 LCD Magnifier on the housing:
a. Make sure the rubber hood quick release string and eyepiece cap secure strings are tied
around the rubber hood secure loop.
b. Secure the LCD Magnifier to the housing by tying the housing side of the Rubber hood quick
release secure string around the lanyard loop of the housing (preferably bottom left loop).
c. Release the quick release secure string to allow for LCD Magnifier installation on the housing.
d. Install the LCD Magnifier over the anti-glare hood rails at the back of the housing. First hold it
against the rails so that the rubber hood secure loop is found at the bottom left and the
eyepiece is pointed upwards. Install the rubber hood over the top rail (image #1) and then
gently and carefully stretch it downwards to install it on the bottom rail (image #2), making
sure it’s sitting securely on both upper and lower rails (image #3).
Image #1
Image #2
Image #3