1 fantasea nano flash instruction manual 26110120 fantasea nano flash (cat. No. 6115) instruction manual.
2 fantasea nano flash instruction manual 26110120 1. Introduction the nano flash is a universal underwater slave flash especially designed for compact digital housings. It triggers in sync with the camera built-in flash and was designed to significantly improve the colors in underwater photographs, ...
3 fantasea nano flash instruction manual 26110120 nano flash controls & features nano flash housing controls & features 4. Instructions for use a. Test the watertight seal of the nano flash housing prior to installing the nano flash inside the nano flash housing, test the housing in a shallow water ...
4 fantasea nano flash instruction manual 26110120 b. Open the nano flash housing i. Release the security lock by gently pulling it out (image #1). Ii. Rotate the dial lock clockwise till it reaches an angle of 45 degrees (image #2). Iii. Open the rear cover and take the nano flash out of the housing...
5 fantasea nano flash instruction manual 26110120 d. Install the nano flash inside the housing i. Make sure that the both the pre-flash mode dial on the nano flash housing and the pre-flash mode control on the nano flash are set to the “test/off” position. Ii. Slide the power switch at the back of t...
6 fantasea nano flash instruction manual 26110120 what are pre-flashes? Pre-flashes are one or more flashes given out to assist in the focusing and exposure setting of the camera before the actual picture-taking primary flash is fired. It is important to set the nano flash to the correct pre-flash s...
7 fantasea nano flash instruction manual 26110120 g. Mount the nano flash on an arm i. Remove the screw from the y-s connector at the bottom of the nano flash housing by unscrewing it all the way out. Ii. Position the nano flash on top of the arm so that the y-s mount on top of the arm is aligned wi...
8 fantasea nano flash instruction manual 26110120 stabilize the fiber optic cable inside the adaptor, but don't tighten it too strongly. Tightening the screw too much might damage the fiber optic cable. Iii. Install the black and clear plastic diffuser cover on the nano flash housing. Iv. Insert the...
9 fantasea nano flash instruction manual 26110120 vii. It is preferable to totally block out the internal flash of the camera after attaching the camera side of the cable by applying black electrical tape over the fiber optic connector attached to the housing case. This effectively achieves two thin...
11 fantasea nano flash instruction manual 26110120 can be used to absorb part of the light when the flash is too powerful, even when set to the lowest output. In order to install any of the flash diffusers, first install the diffuser holder on the flash housing by simply clicking it in. Then slide a...
11 fantasea nano flash instruction manual 26110120 ix. Never use petroleum, alcohol, benzene and paint thinner to clean the flash, housing or o-ring. Fantasea products consumer limited warranty “fantasea” warrants this fantasea line branded product against defects in materials and workmanship under ...
