Fantech SHR 14105R Installation manual - Maintenance
11
MAINTENANCE
The filters need to be checked and cleaned once a month or when they appear dirty.
FILTERS
The motor
- The motors are
factory balanced and lubri-
cated for life. They require no
maintenance.
The unit
- The inside of the
unit should be wiped clean
as needed.
Condensation Pan
- Units
with drain hoses should have
their line and connection
checked regularly.
Outside hoods
- The outside
hoods need to be checked
every season to make sure
there are no leaves or insects
blocking the airflow. Check
regularly that there are no pol-
lutants near the intake hood.
Make sure they are clear of
any snow accumulation during
the winter months.
Clean cores on a average every 3-6 months or as needed.
a) Open access door & remove filters.
b) Carefully pull on handle of core and pull evenly outward.
Cores may be snug, but will slide out of the channel.
c) Wash the cores in warm soapy water or light coil
solution.
d) Install clean cores making sure the matting sur-
faces have one sealing edges between each cores
to minimize leaks.
e) Install the clean filters
f) Replace access door
Note
: Core installation label on the outer end of the core.
To install the clean Core and Filters.
a) First mount the bottom flange of the core guide into the
bottom channel approximately 6mm (1/4")
b) Mount the left or right side flange of the core guide
approximately 6mm (1/4") followed by the other side
c) Mount the top flange of the core guide into the top
channel approximately 6mm (1/4")
d) With all four corners in place and the core straight and
even, push hard in the centre of the core until the
core stops on the back of the cabinet.
CAUTION
MAKE SURE UNIT IS UNPLUGGED BEFORE ATTEMPTING ANY MAINTENANCE WORK
The following components should also be inspected regularly and well maintained.
FIXED PLATE
INSTALLATION EXAMPLES CON'T
INTERIOR WALL
EXTERIOR WALL
EXTERIOR WALL
POOL HRV
EXTERIOR WALL
AIR HANDLER
RECIRCULATION
BACKDRAFT DAMPER
MDH1 Control
EDF1R Control
MECHANICAL ROOM
HVAC